User manual IRISBOND Quick Start Guide: iOS
See it Possible
7
www.irisbond.com
How to mount Oskol
Oskol has a space dedicated for the iPad and another for Hiru. To mount the
iPad in the Oskol follow these steps:
Click here to watch How to insert and remove your iPad from Oskol.
Identify the top connection point, and
ensure the screw is removed. The screw will
be shipped in the bag below the Oskol.
Separate the top and bottom pieces of
the casing. Push up on each side joint to
separate them.
Place the iPad in the bottom piece of the
casing. The bottom corners of the iPad
should sit tightly in the casing.
Place the hub and spring in the
compartment. The hub’s ports should
facing the outside edge of the casing, so
they are accessible through the space
in the casing. Place the spring in the
compartment, to the left side of the hub,
to provide a tighter t.
Place the top piece over the the iPad.
Slide the top piece down until it is in
place. The side joints and middle piece
should t together.
Place the screw back in the top
connection point. Use the allen wrench to
tighten the screw.
Place the Hiru in the compartment
below, and connect the cables. Connect
the USB-C cable to the Hiru. Connect the
hub to the iPad.
1
2
3
4
5
6
4
3
2
1
2
5
5
7
7
3
6
7
7
7
