iRobot Scooba 200 Series User manual

iRobot Scooba 200 Series Quick Start Guide
www.irobot.com
iRobot Scooba 200 Series Quick Start Guide
• Before using Scooba for the rst time, plug in and charge Scooba until green light on charger is
solid (up to 8 hours).
• Sweep the oor prior to using Scooba.
Floor Types
Scooba is designed for use on hard oor surfaces, including tile, linoleum, vinyl, marble, slate, stone
and sealed wood. Scooba is not recommended for use on unnished or unsealed hard oor surfaces,
carpet, rugs or waxed oors. Scooba is not intended for use on laminate ooring, which may be
damaged by wet cleaning methods.
Cleaning Solution
Scooba is designed to work only with Scooba Hard Floor Cleaner or plain tap water.
Filling the tank
Slowly add clean water to Scooba’s ll port,
then add one full sample packet or ½ capful
of Scooba Hard Floor Cleaner.
(Do not use hot water.)
For Best Performance
• Remove clutter and lightweight rugs from area to be cleaned.
• Always empty and rinse both tanks after the cleaning cycle is complete.
(See Instructions for Use section.)
• Keep wheels, brushes and squeegee free from hair and debris by inspecting and cleaning the
wheels and bottom plate after each use.
• To protect bottom plate brushes, keep Scooba on storage mat, when not in use.
Battery Life
To extend the battery life, always store Scooba connected to a plugged-in charger.

iRobot Scooba 200 Series Quick Start Guide
www.irobot.com
Instructions for Use
Before using your Scooba for the rst time, you must:
Your charger will ash twice when plugged in to show that it has power.
Your Scooba battery is fully charged when the light on the charger is solid green.
Using Your Scooba
These steps will guide you through setting up and cleaning the oor with your Scooba
Emptying and Cleaning Your Scooba
1
Slowly add warm
water into FILL port.
Open both FILL and
EMPTY ports so
bladder can fully
expand. (Do not use
hot water.)
2
Add Scooba Hard
Floor Cleaner.
(1 packet or ½ capful)
3
Firmly close
FILL and
EMPTY
ports until
sealed
4
Place Scooba in the
middle of the dirtiest
area on the oor.
5
Press power button
to turn on Scooba.
6
Press and release clean
button to begin the full
cleaning cycle.
For short cycle, press
and hold until second
song starts.
Insert the included
battery into Scooba
Plug in and charge
Scooba overnight
for the first charge.
1
Empty and thoroughly rinse both tanks
with water.
2
Remove bottom plate.
Rinse and remove all debris
from brushes and squeegee.
3
Clear any debris on robot before replacing
bottom plate. If necessary, remove and
replace tires.
Place Scooba on storage mat to protect
bottom plate brushes. Ensure charger jack
door is closed when using Scooba.