WWW.ISADEEHAIR.COM
2.
Do not allow to be used as a toy. Close attention is necessary when used by or
near children. Children
should be supervised to ensure that they
do not play
with the appliance.
3.
If the supply cable is damaged, it
must be replaced or repaired by the
manufacturer, its service agent or similarly qualified persons in order to avoid
a
hazard.
4.
This appliance has a non-self resetting thermal cut out safety device to prevent
overheating. If your appliance cuts out, unplug it from the mains supply socket and
leave to cool.
5.
WARNING
: Do not use this appliance
near bathtubs, showers, basins or other
vessels containing water.
CAUTION
: In order to avoid a hazard
due to inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility
company, or plugged into any socket where the electrical supply is unstable or likely to
be turned off.
When the appliance is used in a
bathroom, unplug it after use since
the proximity of
water presents a
hazard even when the appliance is
switched off. For additional
protection when the appliance is switched off.
For additional protection when the appliance is used in a bathroom, it is
recommended that a Residual Current
Device (RCD), with a residual operating current
not exceeding 30 mA is installed in the electrical circuit supplying the bathroom.
Contact a qualified electrical installer for advice.Do not use the appliance for any other
purpose than drying hair.
Do not handle any part of the plug or appliance with Wet hands.
Do not unplug by pulling on the cable.
To unplug, grasp the plug, not the
cable. The
use of an extension cable is not
recommended.
Do not stretch the cable or place the cable under strain. Keep the cable
away from
heated surfaces and do not wrap the cable around the appliance.
Do not use any lubricants, cleaning
agents, polishes or air fresheners on any part of
the appliance.
If the appliance is not working as it should, if it has received a sharp blow,if it has been
dropped, damaged, left outdoors, or dropped into water, do not use and contact the
factory.