ismoka Magoo User manual

How to replace the Magoo coil head and wick
1. First you must make a single coilhead with a wick. For this you need to buy:
- Kanthal thread
- Silica wick
From ISmoka you can buy this as a Magoo coil and wick kit.
The silica wick is the “cotton”
string which is used to deli er
the liquid to the coil head.
The coil thread is made of
kanthal thread and can ha e
different ohm resistance
depending on the thickness
of the thread.

Wrap the kanthal thread on
the middle of the two silica
strings for se eral laps. This
will create the coil head. It’s
important to lea e enough
length of the silica strings in
both ends to reach the
bottom of the atomizer head.
Then your deli ery string is
done.
It’s important to lea e enough length of the silica strings in both ends to reach the bottom
of the atomizer head (Part A).
Then place the deli ery string in the top slot of part A and wrap the ends around the
atomizer head (part A).
Now you must connect the kanthal thread (heating filament) to the positi e and negati e
pole of the atomizer.

The positi e and negati e pole are separated by a plastic ring and a silicon ring. Place the
two end of the kanthal thread as shown abo e and tighten the rings. Now your atomizer
should work again ☺
If you ha e a dual coil Magoo atomizer head the only difference is that you ha e four slots
on the top of part A. You simply place one deli ery string in each slot, and follow the same
procedure as abo e.