Izzo SWAMI LZ-i User manual

A. Eye Piece
B. Diopter
Adjustment
C. Power Button
D. Mode Button
E. Battery Door
LCD DISPLAY
A. Zero-In Aiming Circle
B. P.A.T. Mode Indicator
C. Unit of Measure
D. Battery indicator
E. Slope Adjusted Distance
F. Angle of Incline/Decline
G. i-Caddie suggested club
RANGEFINDER DIAGRAM
SWAMI LZ-iLASER RANGEFINDER MANUAL
For more support visit: WWW.IZZO.COM

preferred unit of measure (yards/meters). Based on that information, the

you measure.
In the initial “SET” interface screen,

2. While in the “SET” interface, HOLD the POWER button for an additional
3 seconds to toggle to the club distance setting. Tapping the POWER button
MODE
3. Once correct distance is set, HOLD the POWER button for 3 seconds to
OWER button again to
engage the “OUT” screen, then hold the POWER button an additional
3 seconds to return to the main screen.



SET
7I
160
SET
7
170
out
7I
170
1.
the LZ-i laser in the OFF position. HOLD
the POWER
engage i-Caddie set up mode.
HOLDMode
Button



3.  - To measure distances to multiple targets in succession,
PRESS and RELEASE  to power on. Then HOLD
, the 

and change targets.
NOTE: While scanning in P.A.T. Mode, the measurement will only change when a shorter distance


---
Y
SLOPE ON


---
Y
SLOPE OFF
HOW TO USE

, PRESS & RELEASE
the 
is now powered on.
1. To focus/increase clarity, use
the  by
turning the .
2.
 ,
aim the  at your
intended target & PRESS the 

will appear to the right
of the The
measurement will be displayed at the
top of the LCD display.
3.
2.  P.A.T. mode is best used when measuring the

P.A.T mode, PRESS the once while the device is powered

LCD display (Fig. B).
1.  Standard mode is recommended when measuring distances
to larger objects. (Fig. A)
164
---
Y
4.  To change the unit of measure from yards to meters,
start with the device powered on. Then HOLD the 

of the distance displayed.
 on the side of the LZ-i has two positions:
 GREEN is showing:  Slope adjusted yardage

tournament legal when the slope is enabled.
2. RED is showing: 󰀨 The laser is tornament legal
󰀨
HOLDMode Button
