Janome Continental M7 Professional User manual

janome.com
MANUAL DUAL FEED SETTING
INSTRUCTIONS

q
w
r
e
Manual Dual Feed Setting
If you wish to sew patterns other than U1 to U5 and Q1
to Q7 with the dual feed device, turn on the manual dual
feed setting.
To turn on the manual dual feed setting, press the
Function menu key qto open the function menu, then
press the ON key wof the manual dual feed setting.
NOTE:
•The dual feed key rwill gray out if the manual dual
feed setting is turned on.
•The patterns U8 and B14, and the sewing applications
that are not suitable for the manual dual feed setting
are grayed out and cannot be selected.
NOTE:
The sewing results of the manual dual feed sewing may
vary depending upon sewing conditions. Always make
a test stitch on an extra piece of the fabric to check the
sewing results.
867-813-005 (EN)
You may need to adjust the dual feed balance e
depending on the type of fabric. Refer to pages 41-42
of the instruction book for how to adjust the dual feed
balance.
Turn off the manual dual feed setting when the manual
dualfeedsewingisnished.
NOTE:
If the drop feed key in the sewing setting mode is turned
on, the manual dual feed setting will gray out.
If the pattern or sewing application with the feed dog
down is selected, the manual dual feed setting will gray
out.

t
NOTE:
If the drop feed key tis turned on in ordinary sewing
mode when the manual dual feed setting is turned on, a
message will appear as shown.
Press the OK key to turn off the manual dual feed
setting, and the feed dog is dropped.
To cancel dropping the feed dog, press the X key.
NOTE:
If the manual dual feed setting is turned on when the
drop feed key tis turned on in ordinary sewing mode,
the feed dog is raised for dual feed sewing.
NOTE:
If the manual dual feed setting is turned on when dual
feed sewing is turned on in ordinary sewing mode, dual
feed sewing will be switched to the manual dual feed
setting.