Janus AVPro Edge AC-CX42-AUHD User manual

AC-CX42-AUHD
AC-CX62-AUHD
Video and Audio Matrices
Control4 Driver User Guide
Driver developed by

AVPro Edge AC-MX##
Control4 Driver User Guide
Janus Technology Ltd
Copyright © 2016
1
Introduction
This driver has been designed to provide two-way control of the AVPro Edge range of audio
and video matrices, via RS232 or TCP/IP.
Driver Installation & Configuration
Copy the .c4i file from the zip package to your Control4 driver folder location (e.g. My
Documents\Control4\Drivers) and then open Composer. The driver can be found under:
Device Type: A/V Switch
Manufacturer: AVPro Edge
Model: AVPro Edge AC-CX##-AUHD
The driver features a number of properties that report status or control configuration:
Figure 1: Driver Properties

AVPro Edge AC-MX##
Control4 Driver User Guide
Janus Technology Ltd
Copyright © 2016
2
Property
Description
Driver version
The release version of the driver
Status
The current status of the connection with the matrix
Debug Mode
Support Use Only
Debug Subsystems
Support Use Only
Table1: Driver Properties
Driver Commands
In addition to two-way input/output switching, the driver supports a number of additional
commands. Choose Programming and select the matrix switcher in the Actions window;
scroll down and check the Device Specific Command radio button.
Figure 2: Device Specific Commands
Command
Description
Set Ex-Audio Output State
Enable/Disable Ex-Audio
Show System Status
Write the switch’s system status output to the Lua window
Reboot Device
Reboots the unit

AVPro Edge AC-MX##
Control4 Driver User Guide
Janus Technology Ltd
Copyright © 2016
3
Set Video Mode
Set output video mode (2K->4K, ICT Mode)
Set Output Stream State
Set output stream on/off
Set All Output Steam
States
Set all output streams on/off
Set Ex-Audio Output Bind
Set which video output to take extracted audio from
Set Switch Mode
Set switch mode to single/double
Set Ex-Audio Mic Route
Enable/Disable routing MIC IN to extracted audio output
Set Ex-Audio Mic Level
Set the extracted audio output volume level (0-20)
Mute/Unmute All Outputs
Mutes or Unmutes all outputs (individual muting can be done
using the Mute Settings)
HDBT Signal Generator
Set HDBT Output Signal Generator Enable/Disable
HDMI Signal Generator
Set HDMI Output Signal Generator Enable/Disable
Get Current Output Setup
Refresh the current routing for the specific output
Get All Current Output
Setup
Refresh the current routings for all outputs
Table2: Device Specific Commands
AC-CX42/62-AUHD Audio control
Extracted audio can only work for one of the two outputs at any one time. Use the "Set Ex-
Audio Output Bind" command to choose which video output is associated with the audio
output: Output 1 (HDBT) or Output 2 (HDMI). Then bind your connected audio device to the
appropriate connection (STEREO or DIGITAL_OPTICAL) of your chosen output.
If an input device is connected to the MIC IN connection of the driver then selecting this
device will automatically send the command to override extracted audio with the audio from
MIC IN. Re-selecting a video input will revert to extracted audio. In the absence of a
connected input device in the project, switching the MIC IN override on or off can be done
using the "Set Ex-Audio Mic Route" command.