Jeco FCL037 User manual

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 1 of 3
Parts List:
A. Top Bowl Qty: 1
B. Bottom Base Qty: 1
C. Pump and Adaptor
Qty:1
D. LED Lights Qty: 4
Thanks for shopping with Jeco
Bowls on Brick Wall Fountain
with LED Lights
SKU# FCL037 / 15030039
1-800-893-3006
Ontario, CA 91761
Made in China
If you have questions regarding this product, call
1-800-893-3006 Mon.-Fri. 9:00-5:00 PST
(California) and ask for our product specialists, or
e-mail: [email protected]
See many more products on the Internet!
www.jeco-inc.com

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 2 of 3
To Assemble:
Step 1: Route the pre-assembled water hose on the Top bowl (A) to the bottom base (B).
Step 2:
A: Carefully attach the pump (C) to the hose, making sure to place the pump in the center
of the bottom (B).
B: Carefully connect the four single LED lights (D) to the light cable comes out from
pump (C), making sure both parts connect securely.
Step 3: Fill the basin (B) with clean water, making sure the pump (C) is fully submerged.
Note: The maximum water level should be approximately 1.2 inches below the top edge of
the basin (B).

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 3 of 3
Step 4: Finally, connect the plug of pump (C) to a GFCI outlet.
WARNING: Always disconnect the pump (C) before placing your hands in the water.
CARE AND MAINTENCE
To eliminate the possibility of water damage to areas around the fountain, check for
leaks and excessive splashing after the initial set up of the fountain. It is highly
recommended this fountain be placed in an area where it cannot be damaged.
Do not leave the fountain running for extended periods of time when no one is present
to observe the performance.
Check the area around the fountain on a regular basis to ensure there is no leakage.
Do not attend to attempt to move fountain once filled with water.