Jeco FCL057 User manual

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 1 of 3
Parts List:
A. Top Basin Qty:1
B. Large Basin Qty: 1
C. Base Qty: 1
D. Pump Qty:1
Thanks for shopping with Jeco
Grecian Design Bowl Fountain
SKU# FCL057 / 15030022
1-800-893-3006
Ontario, CA 91761
Made in China
If you have questions regarding this product, call
1-800-893-3006 Mon.-Fri. 9:00-5:00 PST
(California) and ask for our product specialists, or
e-mail: [email protected]
See many more products on the Internet!
www.jeco-inc.com

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 2 of 3
To Assemble:
Step 1: Run the cord from the pump (D) through plastic tube at Large Basin (B), making
sure to place the pump in the center of Large Basin (B).
Step 2: Carefully attach the Large Basin (B) to the Base (C), turning it clockwise until it
locks.
Step 3: Connect the water hose to the pump, then carefully attach the first basin (A) to the
Large Basin (B), making sure to place the pump in the center of the Large Basin (B).
Step 4: Fill the basin (B) with clean water, making sure the pump (D) is fully
submerged.
Note: The maximum water level should be approximately 1.2 inches below the top edge
of the basin (B).

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 3 of 3
Step 5: Finally, connect the plug of pump (D) to a GFCI outlet.
WARNING: Always disconnect the pump (D) before placing your hands in the water.
CARE AND MAINTENCE
To eliminate the possibility of water damage to areas around the fountain, check for
leaks and excessive splashing after the initial set up of the fountain. It is highly
recommended this fountain be placed in an area where it cannot be damaged.
Do not leave the fountain running for extended periods of time when no one is present
to observe the performance.
Check the area around the fountain on a regular basis to ensure there is no leakage.
Do not attend to attempt to move fountain once filled with water.