Jeco Peacock FCL163 User manual

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 1 of 3
Parts List:
A. Product Body
Qty: 1
B. Pump Cover
Qty: 1
C. LED Light
Qty: 1
D. Pump and Adaptor
Qty:1
Thanks for shopping with Jeco
Peacock Fountain with LED Light
SKU# FCL163 / 15030107
1-800-893-3006
Ontario, CA 91761
Made in China
If you have questions regarding this product, call
1-800-893-3006 Mon.-Fri. 9:00-5:00 PST
(California) and ask for our product specialists, or
e-mail: [email protected]
See many more products on the Internet!
www.jeco-inc.com

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 2 of 3
To Assemble:
Step 1: Attach the pre-assembled water hose to the pump (D) and attach the LED lights
(C) to the light cable comes out from the pump (D), then place the pump in the center of the
bottom (A), and put the pump cover (B) on the cover the pump.
Step 2: Fill the product basin (A) with clean water, making sure the pump (D) is fully
submerged.
Note: The maximum water level should be approximately 1.2 inches below the top edge
of the basin (A).
Step 3: Finally, connect the plug of pump (D) to a GFCI outlet.
WARNING: Always disconnect the pump (D) before placing your hands in the water.

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 3 of 3
CARE AND MAINTENCE
To eliminate the possibility of water damage to areas around the fountain, check for
leaks and excessive splashing after the initial set up of the fountain. It is highly
recommended this fountain be placed in an area where it cannot be damaged.
Do not leave the fountain running for extended periods of time when no one is present
to observe the performance.
Check the area around the fountain on a regular basis to ensure there is no leakage.
Do not attend to attempt to move fountain once filled with water.