Jensen of Scandinavia EAGLE 1600 User manual

EAGLE 1600
INSTALLASJONSVEILEDNING
NORSK
Koble Eagle 1600 i en ledig stikkontakt i nærheten
av din trådløse ruter
Koble til Eagle 1600 si trådløse neverk med en
PC, nebre etc. Navnet på det trådløse neverket
finner du på toppen av Eagle 1600.
Åpne neleseren og skriv inn jensen.setup
eller 192.168.39.1 i adressefeltet og trykk Enter.
Velg det trådløse neverket du vil forsterke fra
listen og trykk Next.
Lynx_083262
Lynx_9000
Eagle_45ac32
My network
AirLink_4521ac
WiFi network name: Lynx_083262
Skriv inn passordet til det trådløse neverket
og trykk Finish.
Som standard vil navnet og passordet på det forsterkede signalet fra Eagle 1600 være
det samme det eksisterende. Om du ønsker å bruke et annet navn og passord tar du bo
haken ved «Use same WiFi name and password on the Eagle 1600 as existing network».
Skriv inn ønsket WiFi navn og passord og trykk Finish.
Vent til Eagle 1600 kobler seg til og gjør kla. Tilkoblingen er fullfø og Eagle 1600 kan nå plasseres.
Se neste punkt for informasjon om riktig plassering.
Riktig plassering er viktig for at Eagle 1600 skal fungere optimalt. Vi anbefaler
at du plasserer Eagle 1600 midt i mellom den trådløse ruter og området du behøver
dekning. Lampen på Eagle 1600 viser deg status på tilkoblingen. Ved dårlig dekning
flyer du Eagle 1600 nærmere den trådløse ruteren.
Anbefalt plassering
Interne
GrønnOransje
Blinker
oransje
Dårlig signal
Fly Eagle 1600 nærmere den trådløse
ruteren inntil LED lampen lyser konstant grønt.
Lampen vil først lyse rødt
og dereer gå over til å
blinke rødt/grønt når
Eagle 1600 er klar til å
sees opp.
Jeg opplever ustabil forbindelse fra Eagle 1600
Grunnen til dee kan være den er plasse for langt unna den trådløse ruteren.
Forsøk å plasser den nærmere og se om det blir bedre.
Hvordan nullstiller jeg Eagle 1600?
Trykk inn RESET knappen du finner på undersiden av Eagle 1600 i minst 8 sekunder.
Jeg får ikke logget meg inn på Eagle 1600?
For å see opp Eagle 1600 må enheten du bruker (PC, smatelefon, nebre etc.)
være koblet den trådløse neverket den sender ut. Navnet på neverket du skal
koble til står på oversiden av Eagle 1600 (Se punkt 2 i denne manualen).
?Oe stilte spørsmål
Suppo
12 månders gratis telefonsuppo!
Norge: 22 32 30 76
Sverige: 08 38 30 00
Danmark: 70 70 21 22
Finland: 09 455 21 22
Åpningstider:
Mandag - Fredag: 08.00 - 20.00
Lørdag: 14.00 - 18.00
Du kan også sende oss en epost til:
suppo@jensenscandinavia.com
WIFI RANGE
EXTENDER
Use same WiFi name and password on
the Eagle 1600 as existing network
Connecting to WiFi netowork..Please wait...
Connected successfully to selected network!
The WiFi name of Eagle 1600 is now changed to Lynx_083262
Please re-connect to this WiFi name.
WiFi Network Name (SSID):
Setup link for WEB browser:
jensen.setup
Eagle_0833CD Select WiFi network
Please select your WiFi network
hp://jensen.setup
Frequency range (MHZ) Max. Transmit Power (dBm/MW)
2400 ~ 2483,5 19.87 dBm (97.1 mW)
Decalration of confirmity with regard to EU Directive RED (Radio Equipment Directive 2014/53/EU):
JensenScandinavia, Norway hereby decalres that this wireless network router meets the
requirements in RED (Radio Equipment Directive 2014/53/EU) the declaration of confirmity may
be consultet at www.jensenofscandinavia.com/rtte
!

EAGLE 1600
QUICK INSTALLATION GUIDE
ENGELSK
Connect Eagle 1600 to a power outlet near
your wireless router.
Use your PC, tablet or smaphone to the Eagle 1600
wireless network. The name of the wireless network
can be found on top of the Eagle 1600.
Open your browser and enter the address
http://jensen.setup or 192.168.39.1 and press ENTER.
hp://jensen.setup
Choose the wireless network you want to
extend from the list and click Next.
Lynx_083262
Lynx_9000
Eagle_45ac32
My network
AirLink_4521ac
WiFi network name: Lynx_083262
Enter the password for the exisiting wireless
network and click Finish.
The name and password for the Eagle 1600 extended wireless network is the same as
the existing wireless network. If you wish to use a dierent name and password you can
do so by click "Use same WiFi name and password on the Eagle 1600 as exisiting network".
Then enter the name and password you want to use and click Finish.
Wait for the Eagle 1600 to connect and complete
the setup
The setup is now completed and you can now place
the Eagle 1600. See next step for information and tip
about placement.
Correct placement of Eagle 1600 is impoant for best peormance. We recommend
to place the Eagle 1600 in the midle of your wireless router and the area you need coverage.
The LED on Eagle 1600 will show you the connection status. Move the Eagle 1600 closer
to wireless router until you get good coverage/peormance.
Recommended placement
Internet
GreenOrange
Flashing
orange
Bad signal
Move the Eagle 1600 closed to the
wireless router until LED is steady green.
The LED indicator on the
Eagle 1600 will be solid red
when it is staing, and then
begin flashing to indicate
successfull sta.
I have problems with unstable connection for the Eagle 1600
The reason may be that the Eagle 1600 are placed to far away from your wireless
router. Please try to move the Eagle 1600 closer to the wireless router.
How do I reset the Eagle 1600 to factory default seings?
Press the Reset buon on the underside of Eagle 1600 with a paperclip
for at least 8 seconds.
I cannot login to the Eagle 1600 setup?
In order to setup the Eagle 1600 you need to be connected to the
wireless network from the Eagle 1600. The name of the wireless
network can be found on the top of Eagle 1600 (see step 2).
?Frequently asked questions
Suppo
12 months free phone suppo
Norway: 22 32 30 76
Sweden: 08 38 30 00
Denmark: 70 70 21 22
Finland: 09 455 21 22
Monday - Friday: 08.00 - 20.00
Saturday: 14.00 - 18.00
You can also send us an email to:
suppo@jensenscandinavia.com
WIFI RANGE
EXTENDER
Use same WiFi name and password on
the Eagle 1600 as existing network
Connecting to WiFi netowork..Please wait...
Connected successfully to selected network!
The WiFi name of Eagle 1600 is now changed to Lynx_083262
Please re-connect to this WiFi name.
WiFi Network Name (SSID):
Setup link for WEB browser:
jensen.setup
Eagle_0833CD Select WiFi network
Please select your WiFi network
Decalration of confirmity with regard to EU Directive RED (Radio Equipment Directive 2014/53/EU):
JensenScandinavia, Norway hereby decalres that this wireless network router meets the
requirements in RED (Radio Equipment Directive 2014/53/EU) the declaration of confirmity may
be consultet at www.jensenofscandinavia.com/rtte
Frequency range (MHZ) Max. Transmit Power (dBm/MW)
2400 ~ 2483,5 19.87 dBm (97.1 mW)
!