Jensen BUDDY User manual

1x
1x
1x
1
100%
2 hours
Charging your speaker
Please charge your speaker for 2 hours.
The front LED light will lit red when charging and then turn off when fully charged.
You can use the speaker while charging.
2Power on your speaker
Press and hold the power button for 3 seconds.
Your speaker is now ready to be connected (LED flashing blue on front)
3 seconds
Flashing
blue
3Connect your device
From your bluetooth device
open the bluetooth menu
and connect to Buddy.
ON
Bluetooth
General
Bluetooth
Devices
Buddy Not Connected
Telenor 12:15 97%
Charging cable
Audio cable
Charger
Select
Buddy
ON Bluetooth
Min enhet
Tilgjengelige enheter
Min telefon
Bare synlig for parede enheter
Buddy
Søk
12:15
Select
Buddy

Disconnect
You can disconnect a connected bluetooth device by pressing the power button for 1 second.
The speaker is now ready to be connected by a new bluetooth device. (LED flash blue)
Press for 1 second
Flashing
blue
LED light
i
= Not connected / pairing mode
= Low battery
= Charging
Hereby, Jensen Scandinavia AS, declares that Buddy is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC. The declaration of confirmity may be consulted at www.jensenscandinavia.com/rtte/
• A fully charged battery gives up to 12 hours playback time when used
at 50% sound level.
• The speaker will switch off automatically if not used for 10 minutes.
• The speaker are dust protected and can resist water immersion up
to 1m for 5 minutes.
• The speaker can be used in rainy conditions.
• If the speaker has been immersed in water, please drain by shaking the
speaker with connectors facing down.
Warranty
Your speaker has 3 years warranty from the date of purchase.
Water proof warranty (immersed in water) is limited to 1 year.
Important information
i
i
Solid BLUE
Flashing BLUE
Flashing WHITE
Solid RED
= Connected