Jetcom CCTV SS-HDR-82 User manual

pre-record H.264 HDMIVGA

In order to ensure your rights and interests, please read this manual carefully before you install
and use the DVR.
Use the appropriate adapter for the DVR.
To protect the main chip from thunder striking, please make sure the groundwire is correctly
connected before using the DVR.
Do not expose the DVR to rain or use it under high humidity circumstance.
This DVR cannot be installed at the places with much dust, and avoid potential mechanical
vibration or impact.
Install this DVR under good air circulation conditions. Do not place it near the heater or under
direct sunlight.
Please choose high quality hard disk (HDD), which could meet the working demand of the DVR.
For its quality, please purchase hard disk from regular merchants, and do not use the Western
Digital hard disk.
CAUTIONS
Network Digital Video Recorder Operation Manual (V1.0 )

Before connecting to other facilities, pleasedisconnect the power supply and pull thepower line
plug out from the power socket.
In case of any solid or liquid coming into the case, please disconnect the power supply
immediately, and the DVR can be restarted only after being checked by qualified servicemen.
If the DVR is not in use for a long period of time, please disconnect the power supply and pull
the power line plug out from the power socket.
This is a precise instrument. No internal part can be repaired by the users. If fault occurs, it is
necessary to ask qualified servicemen to repair it or contact the dealer.
Network Digital Video Recorder Operation Manual (V1.0 )

6
6
8
22
28
Table of contents
Chapter II Operation instructions
Chapter I Product Introduction
1.1 Summary
1.2 Functions and features
2.1 Description of front panel
2.2 Description of rear panel
2.3 Connection figure of rear panel
2.4 Description of alarm port in the rear panel
2.5 Remote control operation
2.6 Mouse operation
Chapter III Menu Setup
3.1 Summary of menu operation
Network Digital Video Recorder Operation Manual (V1.0 )
23
28
27
24
6
8
16
3

3.2 System setup
3.3 Camera setup
3.4 Record setup
3.5 Schedule setup
3.6 Motion alarm
3.7 PTZ setup
3.8 Network setup
3.9 Alarm setup
3.10 Disk management
3.11 User setup
32
31
34
35
36
37
38
39
40
40
40
33
43
44
Chapter IV Basic Operations
4.1 Turn on DVR
4.2 Live screen
4.3 Software update
4.4 PTZ control
Network Digital Video Recorder Operation Manual (V1.0 )
4
29

Appendix 1 Technical parameters
Appendix 2 Trouble shooting
47
47
48
48
51
52
53
53
54
55
57
51
4.5 System information
4.6 Log list
4.7 Recording preparation
4.8 Recording operation
4.9 Search, playback and backup
4.10 Audio setup
4.11 SEQ
4.12 Spot output
4.13 User login
4.14 PC Client software instruction
4.15 Power off
Network Digital Video Recorder Operation Manual (V1.0 )
5
46

1.1 Summary
Chapter I Product Introduction
1.2 Functions and features
Network Digital Video Recorder Operation Manual (V1.0 )
6
This equipment is a standalone digital hard disk video recorder specially designed for security. Itadopts the
embedded processor and embedded operating system and integrates with latest technologies in IT field, such asvideo
frequency/audio frequency compression/decompression, large capacity hard disk storage, TCP/IP networkremote
control etc., investing the system with high intellectualization and stability.
This equipment supports various networks including Ethernet and Internet torealize remote audio/video
synchronization. With easy operation, it can be applied to the security for banks, telecom, schools, hospitals,
supermarkets,residential quarters, factories, companies, warehouses, restaurants, hotels, parks, museums, water
conservancy facilities, entertainment places and other fields.
Support PAL& NTSC video signal input.
Support OSD languages of multiple countries.
Support external alarm, motion detection and time recording.
Support audio recording, audio playing and live mode listening.
If the electricity suddenly off while recording, it will record automatically when power on.

Support CMS.
Support DDNS.
Support network preview, playback, setup, remote recording, PTZ control and camera name setup.
Support IE browsing and Network remote Client.
Support Internet backup ,USB backup.
Support mouse operation with high sensitivity.
Support 2000G hard disk and DVD Writer.
Support HDMI VGA output.
Support HDMI and YPbPr output.
Support Remote Control and Control Keyboards operation.
Convenient & precise video searching.
Control PTZ and speed dome through RS485.
Specially designed dedicated file system for video to increase more than 10 times of service life of hard disk.
Fully independent from PC platform and free from computer breakdowndue to improper operations, complicated.
management & operations as well as virus infection, and with high stability.
Operating system: Linux
Compressed chip: SOC
Network Digital Video Recorder Operation Manual (V1.0 )
7

Chapter II Operation Instructions
2.1 Description of front panel
1
DescriptionNameNo.
Power
Network Digital Video Recorder Operation Manual (V1.0 )
8
2
123456
7
Number keys
Press it to turn on/off the DVR. The same as the " " key in the remote control.
a) input numbers.
b) keystroke 1~9 : select channels.
c) [0/10+]: input the number "0". Press it twice toselect channel10. Combined
number keys 1~9 to select the channels from channel 11 to 16.
d) input password.
19
0/10
Icon
Front panel A:Front panel A:

3
4
LED Indicator
light
HDD Hard drive LED indicator light. It is flash when hard drive is being used.
IR Receiver
Record
Playback/
Pause
Stop
Search
Start recording. In PTZ mode, it is used as [Z+] key on the remote control.
Press it topop up search menu, select the time segment and press it to play.
Press itagain to pause. In PTZ control mode, it is used as [Z-] key on the
remote control.
In playback mode, press it to stop playing and return to searchmenu; invideo
recording mode, press it to stop recording; in PTZ mode, press it toview preset
image.
Press it to enter search menu. In PTZ mode, press it to set preset image.
Record LED indicator light. It is on in recording mode.
REC
IR Remote signal receiver LED indicator light. It is on in remote control usable
mode.
Alarm LED indicator light. It is on when alarm happened.
Network LED indicator light. It is on in network connection mode.
ALARM
NET
LOCK Lock LED indicator light. It is on in locking mode.
Receive signal from remote control. (Do not cover).
Network Digital Video Recorder Operation Manual (V1.0 )
9
5

5
Backup
PTZ
COPY
INFO
ESC
SEQ
AUDIO
MENU
Menu
Press it to enter backup menu.
Network Digital Video Recorder Operation Manual (V1.0 )
PTZ
Information
Exit
Sequence
Audio
Press it to enter PTZ mode, press again to exit.
press it once to pop up a tool menu on the top right of the screen, pressit again
to enter into system information menu, press it three timesto pop up log list menu.
Press it to exit from the inferior menu and return to the superior menu. In
record/playback mode, press it to turn back to live mode.
In live preview mode, press this key to switch full screen images by sequence.
Press it to pop up audio setup menu.
Press it to pop up the main menu
SPOT output
Lock
Press it to pop up SPOT setup menu.
Lock the machine.
SPOT
LOCK
Direction /
split/
confirm keys
a) are direction keys. In menu mode, select the listed options
upward/downward/leftward/rightward; in PTZ control mode, control the dome
to rotate upward/downward/leftward/rightward. confirm the selection and
operation. b) could be Quad, nine-split-screen and16-split-screen
key in live mode. c) rewind and forward in playback mode. Change
the parameters value in menu mode.
10

6
7
Network Digital Video Recorder Operation Manual (V1.0 )
+
-
Shuttle
USB port Connected to USB pendrive or mouse and used for system software upgrade
or video file backup; It supports hot plug.
In playback mode: rotate the shuttle outer ring Leftward / rightward once tofast
backward/forward at 2 speed, rotate it twice toplayat4 speed; Rotate it third
time toplay at8 speed, four times for 16 , five times for32 , six times for
64 ,In menu mode: rotate the shuttle outer ring leftward/rightward once to in
crease/decrease the set value, rotate it leftward /rightward to the end to increase/
decrease the set value successively; rotate the inner ring leftward/rightward to
move the cursor upward/downward.
11

Front panel B:Front panel B:
Network Digital Video Recorder Operation Manual (V1.0 )
1
NameNo.
Information key
Number keys
2
3
Icon
INFO
1~16
press it once to pop up a tool menu on the top right of the screen, press it again
to enter into system information menu, press it three times to popup log list menu.
a) Keys [1~9] used to input numbers and password.
b) Keys [1~16] used to select channels.
c) [10]: input the number 0"".
Description
IR Receiver Receive signal from remote control. (Do not cover).
12
12 3
7
6
4533

3LED Indicator
light
4
5
POWER
HDD
LOCK
REC
PLAY
IR
SEQ
PTZ
NET
ALARM
It is red in running mode, it is green in standby mode. It is off in power off mode.
Hard drive LED indicator light. It will flash when the HDD is being used.
Lock LED indicator light. It is on in locking mode.
Record LED indicator light. It is on in recording mode.
Play indicator light. It is on in playback mode.
Remote signal receiver LED indicator light. It is on in remote control usable
mode.
Channel sequence LED indicator light. It is on in channel sequence mode.
PTZ control LED indicator light. It is on in PTZ control mode.
Network LED indicator light. It is on in network connection mode.
Alarm LED indicator light. It is on when alarm happens.
Direction keys
They are direction keys. In menu mode,select the listed options upward/
downward/leftward/rightward; in PTZ control mode, control the dome to rotate
upward/downward/leftward/rightward.
confirm the selection.
USB port Connected to USB pendrive or mouse and used for system software upgrade
or video file backup; It supports hot plug.
Network Digital Video Recorder Operation Manual (V1.0 )
13

5
6
MENU
Menu
BAK
AUDIO
PTZ
Quad key
Nine-split key
Sixteen-split key
Backup key
Audio key
Fast Forward/
rewind key
Press it to pop up the main menu.
Press it to exit from the inferior menu and return to the superior menu. In
record/playback mode, press it to turn back to live mode.
Increase or decrease the data value.
+/-
Press it to enter PTZ mode, press again to exit.
In live mode, press it to display four-split-screen.
In live mode, press it to display nine-split-screen.
In live mode, press it to display sixteen-split-screen.
Press it to enter search menu for backup.
Press it to pop up audio setup menu.
In playback mode: press once to fast forward /rewind at2x speed,
press ittwice to play at 4x speed; press it third time to play at 8x speed, four
times for 16x, five times for32x, six times for 64x; press it once more toreturn
to normal play speed.
Startrecording. In PTZ mode, it is used as [Z+] key on the remote control.
Pressitto pop up search menu, select the time segment and press it to play.
Press itagainto pause. In PTZ control mode, it is used as [Z-] key on the
/
PTZ
/
Playback/ Pause
Record
ESC
Exit
+/-
Network Digital Video Recorder Operation Manual (V1.0 )
14

7
In playback mode,press it to stop playing and return to search menu; in video
recording mode, press it to stop recording; in PTZ mode, press it to view
preset image.
Press it to enter search menu. In PTZ mode, press it to set preset image.
Stop
Search
Shuttle knob +
-
Network Digital Video Recorder Operation Manual (V1.0 )
15
remote control.
In playback mode: rotate the shuttle outer ring Leftward / rightward once to fast
backward/forward at 2xpeed, rotate it twice to play at 4x speed; Rotate it third
time to play at 8xspeed, four times for 16x, five times for32x, six times for 64x.
In menu mode: rotate the shuttle outer ring leftward/rightward once to increase/
decrease the set value, rotate it leftward /rightward to the end to increase/
decrease the set value successively; rotate the innerring leftward/rightward to
move the cursor upward/downward.

Network Digital Video Recorder Operation Manual (V1.0 )
2.2 Description of rear panel
16
11 12 13
11 12 13
Rear panelAof 4 channel:
Rear panelAof 8 channel:
Y
Y
Pr
Pr
Pb
Pb

Network Digital Video Recorder Operation Manual (V1.0 )
Video input
Video output
Standard BNC port, connected with the camera and speed dome.
Connected with the video input of the monitor.
Port
No. Description
17
11 12 13
Rear panelAof 16 channel:
SPOT Connected with spot output device to view the live image independently.
NET Standard RJ-45 network port, connected to network cable and used for
remote browse or control.
PrPb

Network Digital Video Recorder Operation Manual (V1.0 )
HDMI
Audio output
Audio input
Power
Connected with earphone or cable speaker.
Connected with audio input device, e.g. microphone.
USB Connected to USB pendrive or mouse and used for system software upgrade
or video file backup; It supports hot plug.
AC 220V or 110V.
18
YPbPr
Loop output Standard BNC port, connected with the monotor etc.
RS485 devide into Aand B. it can control PTZ via the mouse, remote control
and network Client.
Connected with alarm inout and output.
It is Remote IR Receiver Port, connected with External Remote Control Receiver
connector.
485
IR
ALARM
VGA VGAvideo signaloutput port, connected with the VGAport of a computer
monitor.
It is used to connect with HDMI device.
It is used to connect with HDMI device.

Rear panelB of 8channel:
12
11
Network Digital Video Recorder Operation Manual (V1.0 )
19
Rear panelB of 4channel:
12
11
PrPb
PrPb