JL Marine Power-Pole C-Monster Series User manual

9010 Palm River Road. Tampa, FL 33619 phone [phone] fax [phone] power-pole.com
iOS Module Instructions - Power-Pole C-Monster Pumps
What you will need
1. Laptop running Windows XP or newer.
2. Philips head Screw driver.
3. Access to your pump with power.
4. A Mini USB cable (not provided with your system)
-
iOS module upgrade procedures
1. Download and install the iOS module update from the Power-Pole website.
2. Open the setup.exe file and go through the set up process.
3. Run the Driver Setup; Start --> All Programs --> JL Marine --> iOS--> Driver Setup
4. Remove the (4) Phillips head bolts that hold the cover on the C-Monster motor assembly.
5. With the cover removed, disconnect the membrane switch ribbon wire from the circuit board by
gently pulling on it.

9010 Palm River Road. Tampa, FL 33619 phone [phone] fax [phone] power-pole.com
6. Carefully slide circuit board upward out of the C-Monster motor assembly.
7. Install the iOS module onto the circuit board with bottom edge flush with the circuit board.
8. Re-install the circuit board into the motor housing by using the grooves to align it.

9010 Palm River Road. Tampa, FL 33619 phone [phone] fax [phone] power-pole.com
9. Route the white antenna wire according to the photo to avoid signal interference.
10. Plug the pump cap ribbon wire back into the circuit board with dark side facing upward.
11. Connect the USB Cable to the motor’s circuit board and your computer.

9010 Palm River Road. Tampa, FL 33619 phone [phone] fax [phone] power-pole.com
12. Open the iOS boot loader program update , ; Start --> All Programs --> JL Marine --> iOS -->
Upgrade Utility. You should see a screen such as the one below.
13. Put the Pump into program mode. This can be accomplished in one of two ways:
1. Press and Hold the program button while turning power to the pump off and then
on again. Then hold program button for one more second. Or
2. Press and Hold all (3) buttons on the motor cap, release the up and down, while
holding just the program button for one more second.
Once the led indicator light stays solid you have booted the motor into program mode.
14. Press the “Upgrade” button to update your C-Monster pump.

9010 Palm River Road. Tampa, FL 33619 phone [phone] fax [phone] power-pole.com
15. Remove USB cable and replace pump cover once the program is complete.
16.Now with your iPhone, go to the Apple store and download the free C-Monster app to
utilize all the great features your Power-Pole has to offer.
For Technical Support Call 813-689-9932 opt 2.