Johnson Vintage 30 User manual

Vintage Series Guitar Ampli er
INSTRUCTION MANUAL
MODEL:
Vintage 30

2
       


        
 
PANEL FUNCTIONS
INTRODUCTION
Thank you for choosing this Johnson amplifier. Please read this manual
carefully
and completely before operating your new amplifier.
1
INPUT JACK
Connect the cable from your instrument’s output jack to
this jack. Always use an undamaged, shielded instrument
cable.
2
OVERDRIVE
Used for adjusting the amount of distortion.
3
LEVEL CONTROL
Used to adjust the overall output volume of the amp. Use
this control along with the output volume control on your
instrument to achieve a balanced volume from your instru-
ment.
4
BASS CONTROL
Used to shape the amplifier’s tone by adjusting the bass fre-
quencies.
5
MIDDLE CONTROL
Used to shape the amplifier’s tone by adjusting the middle
frequencies.
6
TREBLE CONTROL
Used to shape the amplifier’s tone by adjusting the high-end
frequencies.

3
7
HEADPHONE JACK
Used for private listening. Uses a 1/4” jack connector.
(Speaker is disengaged when headphone jack is in use.)
8
POWER INDICATOR LIGHT
LED glows when the unit is turned on.
9
POWER SWITCH
This switch turns the unit ON and OFF.

4
SUGGESTED SETTINGS
Clean
Rock
Blues

5
TECHNICAL SPECIFICATIONS
POWER SUPPLY
110/115VAC/50Hz~60Hz
POWER OUTPUT:
15 watts RMS @ 8 ohms
LOAD IMPEDANCE:
8 ohms
INTERNAL SPEAKER:
8” in diameter
INPUT:
1/4” Mono Jack
DIMENSIONS:
13”(W) x 13 3/16”(H) x 7”(D)
WEIGHT
(approx.):
14.5 lbs.