Joy Elevate II Instruction Manual

Elevate II
Tilting & Rotating Module
Assembly Instructions
90˚
75˚
Contents
x4 x8 x1x4x4
A x1 B x1
S1 S2 S3
x4
S4 S5 S6
C x1
D x1
A1
A2
A3
A4
A5
A6

Installation / User manual
Using the included wrench(S6), loosen
nut (A1) and remove all pieces (A1-A6).
A1
A2
A3
A4
A5
A6
1
A
S6
Loosen
Place hinge (A) on top of plastic
washer (B) & Kiosk pole. Install the 4
screws (S1) into the pole neck to
secure the hinge down. Pull the cable
out through the central hole of the
kiosk and module.
Kiosk pole
Metal opening
facing forward
2
A
B
S1
8 o'clock
orientation
2 o'clock
orientation
B
Install the hinge shroud (C) ensuring the
bottom bumper meets the plastic
washer gap (B), then turn the shroud 90
degrees counter-clockwise until it is
locked.
Ensure proper
alignment
Ensure proper
alignment
3
C
90˚

Slide the cover (D) onto the hinge, then
reinstall and tighten all hardware (A1-A6)
in the order shown.
Align the 4 inner holes to install the
hinge and second circle of the 4 holes
to install the enclosure with the
corresponding screws.
Tighten
4
D
A1
A2
A3
A4
A5
A6
A4 A5
Be aware of the metal
bump of A5 must insert into
the quater slot of A4
5
for Plastic
Enclosure
S4
S3
(outter circle)
S2
(inner circle)
S4(outter circle)
S2(inner circle)
for Metal
Enclosure
Washer(S4) needed
© The Joy Factory, Inc.
Email us at [e-mail]
or call us at [phone]