1. on / off9. home
6. mode
7. UV-light
3. timer
5. left
4. forwards
10. collide
2. start / stop
8. suction engine on / off
5. reverse
5. right
Error indication TROUBLESHOOTING
E 1: Front drop sensor over time Sensors can be dirty – Please clean it with a tidy and dry cloth.
E 2: Master unit lift up Please switch off and on the master unit.
E 3: Bumper touch over time Please briskly tap the bumper several times to eliminate any dirt that my be underneath.
E 4: Dust bin was not set up Please check if the dust bin is set up correctly.
E 5: Left wheel is overload Please check if left wheel is fixed and clean.
E 6 : Right wheel is overload Please check if right wheel is fixed and clean.
E 7: Side brush is overload Please clean side brush of hairs and any dirt.
E 8 : Rolling brush is overload Please clean rolling brush of hairs and dirt.
E 9 : Vacuum motor is overload Please clean the suction shaft.
E10: Charging error Please check if the battery is locked.The charging station must be cabel-connected properly.
E11: Battery over heating Please let it cool down for at least an hour.
General handling
The Jt Robot 1000 must be completely charged before vacuuming.
Eliminate everything which can be caught up in the brushes or suction shaft. Prepare your rooms as you usually
do it before conventional vacuuming. Remove or conceal power cords which can be caught up or carried.
For example behind plants, chairs or the sonic-wall.
Don’t use the Jt Robot 1000 for cleaning long-haired,plushy or fringed carpets.
Place the master unit on a hard floor in the middle of the room which you want to clean.
Scheduling Jt Robot 1000
■ Press “time” button
■ Press “week” button until the actual date appears
■ Press “hour” button until the actual hour appears
■ Press “min” button until the actual minute appears
■ Press “time” button to finish
Setting a schedule
■ Press button 2 for time setting.
■ Press button »week« to select the day you wish to vacuuming automatically.
■ If the correct day flashes up,press the button »week« again.
■ Press button »hour« until the correct hour is shown.
■ Press button »min« until the correct minute is shown.
■ Press button 2 once again to finish.
Functions of the remote control
on/off – switches the Jt Robot 1000 on or off
Start/Stop – starts or finish the vacuuming of the room
Timer – running time of vacuuming. The equipment starts from 80 minutes and counts down in 10 minutes cycles.
Forward – moves the Robot forwards.
Left/right/reverse – moves the Robot left, right or reverse
Mode – change its various cleaning behaviours
UV – disinfects the air
VAC – activates the suction blower
Home – moves back to the charging station
Collided – avoids collides with objects. Press the button for activating.
1. Button to set the clock
4. Button »week«
3. Button »anytime go
cleaning«
6. Button »minute«
2. Button for scheduling
cleaning time
5. Button »hour«
Your competent representative: Jt Care GmbH · Ebinger Str. 140 · 72393 Burladingen
info@jtcarecompany.de · www.jtcarecompany.de · Hotline: +49 7475 9159-0
