
8) Operation systems: No need for driver installation if the operating system is Windows ME/
2000/XP/Vistaorabove(Windows98isexcepted)
Operation
Please insert a MicroSD card or a TF card before usage. If the card is not inserted correctly,
theblueLEDlightwillflashcontinuouslyafterthecameraisturnedon.
PowerOn
Long press the Power On/Off /Record button for three seconds the blue LED light will flash 5
times to enter into the recording mode. While recording, the blue LED light will keep flashing
slowly. Short press the Power On/Off/ Record button for the glasses to stop recording and
save the video automatically. If you want to record more, please repeat the previously
describedsteps.
SwitchOff
When in standby mode, long press the Power On/Off /Record button the blue LED light
stopsflashing,andyou’llhearthebuzzer.Thecameraisnowoff.
Note:Thedevicewillautomaticallykeeprecordingsafter10minutes.
Reset
UsetheincludedclipandpresstheRESETholeslightlytorestartthedevice.
Note: If you shut down the camera using the reset button while recording, video files will not
besaved.
Charging
1. Connect the camera to your computer via USB cable while in standby mode, and the
red LED light will be on and the blue LED light will be flashing fast. This indicates that
the camera is charging. If the blue LED light stops flashing, the red light is still on, this
meansthatthecameraisfullycharged.
2. Using the included charger the green LED light will be on, indicating that the camera
is charging. Once the charging process is over and the camera is fully charged, the
greenLEDlightwillgooff.
3. In order to activate the maximum battery capacity and to obtain standard working
hours of the builtin, high capacity, lithium polymer battery with memory effect, please
rechargeitFULLYafterthefirstfivetimesitrunsoutofpower.
WebCamera
Connect the USB cable to your computer’s port (no need to insert the memory card), for the
camera to enter in the webcam mode. (It needs to install STK03NU Driver when used as a
webcamforthefirsttime).
Playback
Once you’re done with recording videos/ taking photos, connect the camera to your computer
via an USB data cable. The red LED light will go on, and then long press the Power On/Off
/Record button until the blue LED light starts flashing fast. Once your computer recognizes the
camera,youcanviewyourvideosandphotos.