KAICO OSSC User manual
EDITION
2
3
4
5
6
AV3 - RGBHV
Source Info
Back
Select
Value -/+
Scanline Int.
Scanline Mode
Scanline Type
LCD Backlight Off/On
AV3 - RGBs
AV3 - RGsB
AV3 - YPbPr
7
LCD Backlight Off/On
8
9
10
11
12
Symptom Possible Cause Solution
Certain Genesis/MegaDrive games
don’t work
Coast values need changing Set H-PLL coast pre 3 and post 3
Image has a vertical icker/
shimmer effect
Interlace source connected This is a normal side effect of
lag-free deinterlacing, no action is
required
Image unstable and/or ickers
on and off
Nintendo SNES/Super Famicom
console connected
Try a different display
Horizontal jitter/wobble on image Fine tuning required Try adjusting low pass lter
settings. See the wiki for
recommendations
Missing pixels in the image Wrong line triple mode selected Use generic 4:3 or Generic 16:9 line
triple mode instead
No audio Display incompatibility Use a different display or choose a
different line multiplication mode
No audio Sample mode incompatible Change the Downsampling option
under “Audio options” to 2x
No audio on AV2 Audio toggle switch set to input
mode
Change audio toggle switch (next
to HDMI connector)
No image Sync mode set wrong Press the source button again to
change sync mode. Most common
sync type is RGBs for SCART, YPbPr
for component and RGBHV for
DSub15/VGA
No image Line triple/quadruple/quintuple
enabled
Switch to line double mode. Other
modes are not compatible with all
displays
No image HDMI/DVI handshake failed Power cycle the OSSC
No image Unusual sync signal Power off OSSC and your source.
Power on the OSSC and select the
correct input, then power on your
source
No image and LCD says NO SYNC Source not powered on Check power to source device
No image and LCD says NO SYNC Source not outputting RGB or YPbPr Make sure your source device
outputs RGB and your SCART cable
is wired for RGB
13
Deutsch
Seiten
13-23
Französisch
Seiten
24-34
Italienisch
Seiten
35-45
Spanisch
Seiten
46-56
Japanisch
Seiten
57-67
Englisch
Seiten
2-12
14
15
16
17
18
19
20
Table of contents
