Kamado Joe GASJOE User manual

Shown: GasJoe 38”
KAMADO JOE GASJOE
THE NEXT REVOLUTION IN GRILLING
GasJoe Specifications

Clearances from Combustible Construction
A minimum of 18” from the sides and rear of the grill must be maintained to adjacent vertical combustible construction,
above the counter top level. You should take into account that there is a large volume of heat, and smoke that will
exhaust from the rear of the grill. This may discolor or damage unprotected areas (Figure 02). Do not install under
unprotected combustible construction without using a re safe ventilation system. A minimum clearance of 18” must also
be maintained under the counter top to combustible construction (Figure 01 and Figure 02).
Figure 1
Figure 2
KAMADO JOE GASJOE
INSTALLATION

Figure 3
Figure 4
Clearances from Non-Combustible Construction
A minimum of 6” clearance from the back of the grill to non-combustible construction is required for the purpose of
allowing the lid to open fully (Figure 04). It is desirable to allow at least 6” rear and side clearance to noncombustible
construction above the cooking surface for counter space. If you’ll be using the rotisserie option, this space is essential for
motor and skewer clearance. The grill can be placed directly adjacent to noncombustible construction below the cooking
surface (Figure 03 and Figure 04).
KAMADO JOE GASJOE
INSTALLATION

Cut-out Dimensions for Built-in Grills (Figure 05)
Note: The built-in island construction material should be all non-combustible material. It cannot have any ventilation
holes except for the hole required for the gas supply in the cut-out base.
MODEL A B C
GasJoe 26” 24-1/8” 21-3/4” 9-7/8”
GasJoe 32” 30-1/8” 21-3/4” 9-7/8”
GasJoe 38” 36-1/8” 21-3/4” 9-7/8”
Figure 5
KAMADO JOE GASJOE
INSTALLATION