Electronic Dartboard Karella CB-25 3
Art.Nr. 8089.01
Close to magnetic fields it can come to malfunctionings of the message display.
Darts: Only the provided soft tip darts with plastic tips may be used or similar soft darts with a
weight not higher then 16 g. The soft tip may be no longer as 12 mm of disc penetration depth.
Turn darts clockwise as you pull them from the board. This makes it easier to remove darts and
extends the life of the tips.
It is not allowed to use Darts with steel tips (steeldarts). They would damage the electronics of
this soft dartboard.
The soft darts may be thrown only in intended distance 237 cm (board distance) and with
sensible effort.
The Dartsegments may not be cleaned with abrasive cleaners or similar chemicals.
The segments are produced in a good quality, however, they are a wear product, which you can
buy from your trader and therefore can be exchanged very easily.
Occasionally, a dart will cause a segment to become wedged within the segment separator web.
If this happens, all games will be suspended and the LCD display will indicate the segment
number that is stuck.
To free the segment, simply remove the dart or broken tip from the segment. If the problem is still
not solved, try wigging the segment until it is loose. The game will then resume where it left off.
From time to time a tip will break off and become stuck in the segment. Try to remove it with a
pair of pliers or tweezers by grasping the exposed end and pulling it out of the segment. If this is
not possible, you can attempt to push the tip through to the back of the segment. Use a nail that
is smaller than the hole and gently push the tip until it falls through the other side. Be careful not
to push too far and damage the circuitry behind the segment. Don’t be alarmed if tips break. This
is a normal occurrence when playing soft tip darts. We included a pack of replacement tips which
should keep you supplied for quite some time. When replacing tips, make sure you use the same
type of tips that come with this dartboard.
TECHNICAL SECURITY TIPS
Connect the device only in an according to regulation installed outlet, which voltage agrees with
the technical data of the net adapter. Use exclusively the net adapter, which is included in the
scope of supply. You can also operate the device in place of a AC - adapter with 3 batteries AA
(not included). If you use batteries do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
On no account start running the device, if the device itself shows visible damages or the
connecting pipe. This would be a considerable security risk.
Pull after ending of the play or by any disturbance always the net plug (adapter) from the outlet.
Let make any repair in the device or in the adapter only from a professional workshop. With
independent, improper repair after opening the dartboard considerable dangers for the user can
originate. Besides, in this case there will be lost any warranty claims.
