Keis Heated Body Warmer User manual
O P E R A T I N G I N S T R U C T I O N S
Keis Heated Clothing is istribute in the UK by
Motohaus Powersports Limited PO Box 7092 Hook RG29 1TY
In the interests of pro uct improvement we
reserve the right to make technical an
esign changes without notice.
www.keisapparel.co.uk
Heated appare for
outdoor activities
111
Visit
WWW.KEISAPPAREL.CO.UK
to see the full range of Keis Heated Apparel
and Accessories – All designed to
help you stay out longer!
WARNING: To ensure safe operation follow these instructions
carefully and keep them in a safe place for future reference.
H E A T E D A P P A R E L F O R O U T D O O R A C T I V I T I E S
TECHNICAL DATA
Shell: 94% polyester, 6% Spandex
Li i g: 100% polyester
Voltage: 12V Only
Approximate Curre t Draw: 1.5A
Typical Power: 14W
CARE OF YOUR KEIS HEATED GARMENT
IHand wash at 30 ºC and drip dry only.
IDo not tumble dry or wring.
IDo not iron.
IDo not bleach.
IDo not operate until completely dry.
DUAL
POWER
Keis_A5_Lo-power ladies bodywarmer-v2014
POWERING ACCESSORIES VIA YOUR KEIS HEATED GARMENT
Your Keis heated garment has dedicated power outputs for Gloves,Trousers and Insoles.
NOTE: These outputs remain live all the time the garment is connected to a power source and are not
affected by devices connected in the Controller Pocket. To control accessories powered by these
sockets separate or integral controllers will be required.
HEATED
LADIES
BODYWARMER
SAFETY & ENVIRONMENT FIRST
MANAGE YOUR FUSES
WARNING For your safety it is essential to manage
the fusing to your eis Heated Apparel.
A selectionofuptofLYHfusesissupplieddependingon
thecurrentdrainandpotentialcombinationsofthe
garments.
On delivery the fuse holder in the supply loom may be
delivered without a fuse. To calculate the fuse value
required simply add the current draws for each or the
garments supplied by the 12v Supply Loom and use
the lowest rated fuse that exceeds the calculated
current.
NOTE: A fuse value below the value required may fail
in use.
FOR EXAMPLE: Sleeved Jacket consumes 7A, Insoles
consume 1.3A. Therefore total is 8.3A. Next fuse value
above this is 10A so use a 10A fuse.
PREPARING A VEHICLE TO POWER YOUR KEIS HEATED GARMENT
Your eis heated garment is designed to be powered from a 12V source such as a vehicle battery or
Lithium Battery Pack.
To power your eis garment from a vehicle battery attach the Fused Connection Lead directly to the
battery or other live 12V source taking into account any safety notices issued by the vehicle
manufacturer and observing the polarity Red +ve and Black -ve.
Position the power socket so it is in a convenient position to power your garment and secure if necessary
using cable ties or tape ensuring that it cannot become trapped, damaged or interfere with the normal
operation of the vehicle.
WARNING Always connect the Red +ve lead to the battery first.
Do not dispose of electrical equipment with standard domestic waste.
ContactyourlocalauthorityforGLVSRVDOinformationspecifictoyourarea.
WARNING
IThis electrically heated garment must be used strictly in accordance with the
manufacturer’s instructions. Failure to observe this notice may lead to increased risk of
burns and fire resulting in injury or death.
ISwitch the garment off immediately and check the affected skin at any sign of irritation
or sensation of excessive heat.
IDo not use the garment when wet. If it becomes wet during use disconnect
immediately from the power source.
INever leave the garment unattended when switched on.
IAlways wear clothing between the heated garment and the skin. Do not wear directly in
contact with the skin.
IThis product is unsuitable for young children.
IDo not use this product if you suffer from: heightened or impaired temperature
sensitivity; an inability to sense temperature extremes; circulatory problems resulting
from diabetes or other medical conditions.
IUse this product with 12V systems ONLY.
IAlways observe the correct fuse rating – See ‘Manage your Fuses’.
IDo not modify or disassemble any part of the system in any way.
IDo not use if the product is visibly damaged.
POWERING YOUR KEIS GARMENT FROM A VEHICLE POWER SOURCE
Your eis heated garment must be powered from the vehicle battery via the Fused Connection Lead as
installed above or the optional Cigarette Lighter/Accessory Plug. Ask your dealer for details or visit
www.keisapparel.co.uk.
To operate locate the 12v Supply Lead located in the pocket inside the garment. Simply connect or
disconnect this to and from the power source as required. An optional on/off switch is available.
NOTE: For the garment to function the Plug and Socket located in the Controller Pocket must be
connected together with or without a Controller in series.
POWERING YOUR KEIS HEATED GARMENT FROM A KEIS BATTERY PACK
Your eis garment can be powered directly using the optional eis Battery Pack. Simply pass the 12V
Supply Lead through the button hole in the bottom of the Battery Pack Pocket and connect to any of the
Keis Lithium Battery Packs. For further details ask your dealer for details or visit www.keisapparel.co.uk.
USING A TEMPERATURE CONTROLLER
NOTE: For ultimate comfort this garment is best controlled by a eis Temperature Controller. Ask your
dealer for details or visit www.keisapparel.co.uk.
Open the Controller Pocket and locate and remove the link wire from the connection block and replace
with the Controller. When using the garment without the Controller simply unplug the Controller and
reconnect the link wire to the connection block inside the Controller Pocket.
NOTE: The Link Wire or a Controller must be in place for the garment to heat.
Garme t Curre t
Draw
Outer Gloves
(Pair) 1.0A
Under Gloves
(Pair) 1.0A
Lo Power Ladies
Bodywarmer 1.5A
Hi Power
Bodywarmer 3.3A
Sleeved
Jacket 7A
Trousers 3.3A
Insoles (Pair) 1.3A
Fuses Colour
3A Purple
5A Tan
7.5A Brown
10A Red
15A Blue
NOTE: The potential
current drain when using
several garments can be
excessively high in some
situations. It is your
responsibility to ensure the
power source can provide
the current required in
such circumstances.
Keis_A5_Lo-power ladies bodywarmer-v2014
Do not operate the controller whilst driving!
POWERING ACCESSORIES VIA YOUR KEIS HEATED GARMENT
Your eis heated garment has dedicated power outputs for Gloves,Trousers and Insoles.
NOTE: These outputs remain live all the time the garment is connected to a power source and are not
affected by devices connected in the Controller Pocket. To control accessories powered by these
sockets separate or integral controllers will be required.
