Kelkay Henri H5715F2RL User manual

H5715F2RL
Low Equinox Fountain
STAGE 1
Ensure you have all the correct items
before you begin the assembly
process.
STAGE 2
Lean the large bowl on it’s side, use
some protective material so as not to
cause damage to the bowl and feed the
pump cable through the hole in the
centre, feed all the way through until
there is approx 10cm of cable between
the pump and the bowl.
STAGE 3
Stand the bowl back upright, wrap the
rubber stopper around the cable and
force down into the hole creating a
water tight seal.
STAGE 4
Attach one end of the black tubing to
the pumps nozzle.
STAGE 5
Feed the other end of the tubing up
through the top bowl of the fountain.
The pump sits inside the cavity in the
bottom bowl.
STAGE 6
Sit the top bowl down pulling the
tubing through as you do so as not to
create a kink in the pipe, once satisfied
that the pipe is kink free snip off any
excess tubing.
1 of 2

H5715F2RL
Low Equinox Fountain
STAGE 7
If the fountain is not level or for some
reason the water flows unevenly, use
‘shims’ to level it up; simply slide the
thin end under the side that needs
raising up and snap off once the water
level becomes stable.
2 of 2
IMPORTANT - WINTER CARE
Winter Ice build-up can cause damage to concrete statuary. Follow these tips
to reduce winter weathering to your fountain:
•Disconnect power to pumps.
• Remove adapter from bottom bowl to open drains and let all moisture
out. Keep drains open throughout winter.
• Place an absorbant material like burlap, blankets etc inside
vases/bowls and cover all with a fountain cover.
• Do not allow snow or ice to build up on or against the concrete.
Remove snow before it turns to ice. Do not use salt or chemical ice
removers as these may damage concrete.
ADVISORY NOTICE
HEAVY ITEMS!
Please take care when handling these items