Kelkay 45000L User manual

Easy Fountain Instructions
45000L - Enchanted Garden
STAGE 1
Position the water feature onto a secure and level surface.
STAGE 2
STAGE 3
STAGE 4
STAGE 5
As shown in the diagram above locate the access cavity / water reservoir at the back of the water
feature. Reach inside the feature and carefully bring out the internal water pipe and the LED cables.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.
Carefully fill the feature with sufficient water taking care to ensure the pump is fully submerged.
Position the pump and excess wires inside the access cavity / water reservoir ensuring that the long
pump and LED wire extend out through the opening. Replace the back trapdoor to cover the
opening.
Attach the internal water pipe to the pump outlet and connect the internal LED wires to the adaptor
plug provided.
ELECTRICAL SAFETY: If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.
PUMP FLOW: The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
STAGE 6
Connect the pump and LED adaptor to a mains power outlet.
www.kelkay.com

Easy Fountain Instructions
45000L - Enchanted Garden
TROUBLESHOOTING
Pump
• Never allow the fountain pump to run dry as this will cause damage and invalidate the warranty.
• It is not recommended to leave the fountain running constantly. We suggest turning the fountain
on/off when required.
• Always shut off the power before cleaning and maintaining the pump.
If the water pump fails to operate, check the following:
1. If the pump cannot pump water, check if the power is correctly connected or check if sufficient
water is inside the reservoir.
(a) Check the pump and tubing for any form of obstructions.
(b) Remove the cover with the pump flow adjuster to reveal the pump impeller and gently turn the
rotor to check that it is not broken or jammed.
2. If the pump runs with slow water circulation check the following:-
(a) The flow control on the body of the pump.
(b) Ensure the pump is completely submersed.
3. If any abnormal sound is heard during the pump operation, turn off the power supply and check
the rotor assembly as follows:
(a) Remove the pump cover and rotor plate from the front.
(b) Grip the impeller and gently take out the rotor assembly from the pump.
(c) Rinse the motor assembly and the housing with clean water in order to remove any grit or
debris.
Cleaning and Care Information
• Clean and top-up the water on a regular basis.
• To empty the fountain of water for cleaning or for winter care:
Smaller fountains (that are light enough to be lifted) - the water can be
emptied by simply inverting the fountain and letting the water pour away
through a suitable drain or sink.
Larger (heavier) fountains - water can be removed by using a large sponge
or by purchasing a simple syphon pipe available from aquatic supply stores.
• Always shut off the power before cleaning and maintaining the fountain
or pump.
• For fountains placed outside, we recommend using easyfountain®
Algae Stopper to keep the water clean and clear.
• To clean the fountain use easyfountain® Grime and Lime Cleaner.
• Should you have a build up of algae, we recommend Algae Killer
Quick Clear One Shot to remedy the removal of Algae, however you
should continue to keep your fountain clean with easyfountain® Algae Stopper
and easyfountain® Grime and Lime Cleaner.
• Please note: The Kelkay range of cleaning products and accessories are only available in the UK
and Republic of Ireland.
www.kelkay.com