
Brush off loose dirt with a dry rag or brush.
As necessary, wipe off mud and dirt with a damp sponge.
As needed, wipe out the inside with a damp sponge and mild non-detergent soap.
DO NOT soak in soapy water as this may damage coated fabrics.
Rinse thoroughly to remove any soap residue.
DO NOT use a dryer. Air-dry only.
Always store in a cool, dry area. Mildew will damage fabrics.
DO NOT leave (store) your pack in direct sunlight. UV light will weaken and fade
materials.
Loosen all load-lifter and belt-stabilizer straps, loosen the shoulder straps and hip belt.
Place 15-20 pounds into the pack.
Put the pack on and buckle the hip belt. The pads should rest on top of your hip bones
and tighten across your belly button. Pull in your belly and tighten the belt more than
you would normally wear it.
Shrug your shoulders and adjust the shoulder straps by pulling down and back on
the webbing below each arm until the lumbar and scapula pads rest on your hips and
shoulder blades respectively.
Tension the load-lifter straps, located on the top of the shoulder straps, by
pulling forward.
Position the sternum strap approximately 2 inches below your collarbone. Buckle the
sternum strap and tighten to where it feels comfortable across your chest.
Tighten the hip belt stabilizers on each side and adjust the hip belt to where it’s snug
but not too tight.
Ideally, your pack weight will rest more on your hips than on your shoulders. You can
make micro-adjustments while hiking to vary the position on your hips and shoulders
for all-day comfort.
5
FINE TUNING THE FIT / CARE & CLEANING
CARE & CLEANING
FINE-TUNING THE FIT