Kenmore 415.162080 Installation guide

Assembly Instructions
Liquid Propane Gas Grill
Model No. 415.162080
This Grill Is For
Outdoor Use Only
NO TOOLS
ASSEMBLY
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
CAUTION
• Read and follow all Safety
Statements, Assembly Instructions
and Use & Care Directions before
attempting to assemble and cook.
• Some parts may contain sharp edges,
especially as noted in these
instructions. Wear protective gloves
if necessary.
WARNING
• Read this manual before cooking on
grill. Failure to follow all
manufacturer's instructions could
result in fire or explosion which could
cause property damage, personal
injury or death.
• Combustion by-products produced
when using this product contain
chemicals known to the State of
California to cause cancer, birth
defects, or other reproductive harm.
463843104 / 1-4165337 (01-23-04)
• Parts
• Assembly
• Safety Rules
• Use and Care
• Troubleshooting
To Installer/Assembler: Leave
these instructions with
consumer.
To Consumer: Keep this
manual for future reference.
N
Assembly Questions?
Call 1-800-241-7548
Parts Ordering:
Call 1-800-4-MY-HOME®

2 • 463843104
FOR YOUR SAFETY
1. Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
2. An LP tank not connected for use shall
not be stored in the vicinity of this or any
other appliance.
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, immediately call your
gas supplier or your fire department.
WARNING
Model Number
UPC (on carton) Label Lot # GG
Serial Number
Date Purchased
CAUTION
For residential use only. Do not use for commercial
cooking.
WARNING
CARBON MONOXIDE HAZARD
Burning charcoal releases carbon monoxide which has no
odor and can cause serious injury or death. Never burn
charcoal inside homes, vehicles or tents.
Installation Safety Precautions
•
•
National Fuel Gas Code, NFPA 54 / ANSI
Z223.1
NFPA/ANSI 58.
National Electrical Code, ANSI / NFPA 70.
Use grill only with LP (propane) gas and the regulator/valve
assembly supplied.
Grill installation must conform with local codes, or in their
absence with
. Handling and storage of LP cylinders must conform to
LP Gas Code Grill is not for use in or on
recreational vehicles and/or boats.
• All electrical accessories (such as rotisserie) must be
electrically grounded in accordance with local codes, or
Keep any
electrical cords and/or fuel supply hoses away from any hot
surfaces.
• This grill is safety certified for use in the United States only. Do
not modify for use in any other location. Modification will result
in a safety hazard.
DANGER
Safety Symbols
The symbols and boxes shown below explain what each heading
means. Read and follow all of the messages found throughout
the manual.
DANGER: Indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARNING
WARNING: Be alert to the possibility of serious bodily injury
if the instructions are not followed. Be sure to read and
carefully follow all of the messages.
CAUTION
CAUTION: Indicates a potentially hazardous situation which,
if not avoided, may result in minor or moderate injury.
Call Grill Service Center For Help And Parts
If you have questions or need assistance during assembly,
please call . You will be speaking to a
representative of the grill manufacturer and not a Sears
employee. To order new parts call Sears at .
1-800-241-7548
1-800-4-MY-HOME®
Product Record
IMPORTANT: Fill out the product record information below.

463843104 • 3
TABLE OF CONTENTS WARRANTY
For Your Safety ......................................2
Grill Service Center...................................2
Warranty Information .................................2
Installation Safety Precautions ..........................2
Safety Symbols......................................2
Kenmore Grill Warranty ...............................3
Parts List...........................................4
Parts Diagram.......................................5
Assembly ........................................6-16
Use and Care ...................................17-25
Cooking Chart...............................24
Troubleshooting...........................25-26
KENMORE GRILL WARRANTY
Full 1-Year Warranty on Grill
For one year from the date of purchase Sears will repair or
replace, at our option, any grill part (except for paint finish)
that is defective in material or workmanship.
Limited Warranty on Selected Grill Parts
From one year after the date of purchase for the designated
time periods listed below, Sears will replace the following grill
parts if they are defective in material or workmanship. You
will be charged for labor.
• Lifetime of Grill: Aluminum Top and Bottom Castings
(except for paint finish)
• 2 years: Burner Assembly
WARRANTY SERVICE
Warranty service is available by contacting Sears at
.
WARRANTY RESTRICTIONS
This warranty is void if grill is used for commercial or rental
purposes.
This warranty applies only when the grill is used in the United
States.
This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
Sears, Roebuck and Co., Dept. 817WA,
Hoffman Estates, IL 60179
• 9 years: Electronic Ignition System
(except for ignitor battery)
1-800-4-MY-HOME®

PARTS LIST – Model No. 415.162080
Key Qty Description Part #
1 2 Leg Assembly .......................4502443
2 1 Base ..............................4503192
3 1 Midshelf ...........................4151035
4 11 #10-24x2” Carriage Bolt ...............4080064
5 12 #10-24 Plastic Tee Knob...............4080091
6 2 Wheel Assembly.....................4310002
7 4 1” Hitch Pin.........................4080062 STD624001
8 2 Leg Extender .......................4154556
9 1 Lower Front Panel ...................4154557
10 1 Upper Front Panel ...................4154426
11 1 Upper Panel Wire ....................4156095
12 1 Condiment Wire .....................4151039
13 1 Grill Bottom.........................4580489
14 3 Burner.............................4158121
15 6 #10x1/2”, T-20, Self-Tap Screw .........4080043
16 1 Air Shield ..........................5501035
17 1 Electrode/Collector Assembly...........4153174
18 1 Control Panel .......................4526176
19 1 Hose/Valve/Manifold Assembly .........4524229
20 3 Control Knob Backplate ...............4154574
21 3 #10-24x5/16”, T-20, Self-Tap Screw ......4080090
22 3 Control Knob........................4154558
23 1 Electronic Ignition Module .............4153189
24 1 Ignitor Ring .........................4157145
25 1 Ignitor Wire .........................4153720
26 2 1/4-20x1-1/4” Carriage Bolt ............4080615 STD532512
27 2 1/4-20 Wing Nut .....................4080221 STD541625
28 2 #10-24x1-1/4” Carriage Bolt ............4080074
Key Qty Description Part #
29 1 Tank Wire ..........................4151019
30 4 EndCap...........................4080065
31 1 Side Shelf ..........................4154373
32 5 #10-12x1-7/8” Wing Screw.............4080096
33 1 Tool Holder .........................4154377
34 1 Sideburner Body.....................4526146
35 1 Sideburner Frame....................4501705
36 1 Sideburner .........................5068018
37 4 #10-24 Wing Nut.....................4080063 STD541610
38 1 Sideburner Ignitor Wire................5156110
39 1 Sideburner Knob.....................4154471
40 1 Sideburner Grate ....................4156376
41 1 Grill Lid ............................4580117
42 1 Heat Indicator .......................4157165
43 1 Heat Indicator Retainer Clip ............4157166
44 1 #10-24 Hex Nut (keps) ................4080208 STD541410
45 1 Logo Plate .........................4156081
46 2 3/16” Pal Nut........................4153096
47 2 1/4x1-1/8” Hinge Pin..................4156513
48 1 Handle ............................4154473
49 2 #10-24x1” Machine Screw .............4080302 STD511010
50 1 Lower SwingAway ...................4152125
51 1 Upper SwingAway ...................4156449
52 1 Cooking Grate ......................4152741
53 1 Grease Clip.........................5156607
54 1 AAA Battery ........................4153177
55 1 Ignitor Button .......................4157156
4 • 463843104

PARTS DIAGRAM – Model No. 415.162080
463843104 • 5
1
1
2
3
4
44
4
4
4
4
4
4
5
5
5
5
5
5
5
5
6
6
7
7
7
8
9
10
11
12
13
14
14
14
15
16
15
15
15
17
18
19
20
20
21
21
21
22
22
22
23
24
25
26
26
27
27
28
28
29
30
30
30
31
32
32
32
33
34
35
36
37
37
37
38
39
40
41 42
43
44
45
46
47
47
48
49
49 50
52
53
54
55
51

6 • 463843104
ASSEMBLY – Model No. 415.162080
1Cart Assembly Step 1
Position base on edge with tank hole to left side.
Insert legs into base and attach with carriage bolts
and plastic wing nuts. DO NOT FULLY TIGHTEN.
Insert midshelf into holes on insides of legs, long
wires toward left side. Fully tighten carriage bolts
and plastic wing nuts.
Leg Assembly
Long midshelf wire
to left side.
Base
5
4
USE TOP HOLE
IMPORTANT!
5
Qty. 8
(Plastic)
4
Qty. 8

463843104 • 7
2Cart Assembly Step 2
Insert wheel/hubcap assemblies into
bottom holes on left legs.
Secure beneath base with hitch pins.
See inset below.
Push leg extenders into right legs.
Leg Extender
Wheel/Hubcap Assembly
Completed assembly with
hitch pin in axle bolt.
7
Qty. 2
7

8 • 463843104
3Upper And Lower Front Panel Assembly
Snap the upper and lower front panels together.
Insert the two pins on lower panel into holes in
front of cart base.
Snap the upper panel over the midshelf wire.
NOTE: Rear view of cart.
Wheels are to right side.
Upper panel
snaps onto
midshelf wire.
Upper Front Panel
Lower Front Panel

463843104 • 9
4Upper Panel Wire And Condiment Wire Assembly
Insert panel wire through upper panel and into leg,
then bend wire slightly to insert opposite end.
Hook the outer condiment wires into the top holes
on front of upper panel, then slide remaining wires
into panel holes below the condiment shelf.
Upper Panel Wire
(Bend slightly to insert)
NOTE: Rear view of cart.
Wheels are to right side.
Condiment Wire
NOTE: front view of cart.
Wheels are to left side.

10 • 463843104
5
5
Qty. 2
(Plastic)
26
p/n 4080615
Qty. 2
28
p/n 4080074
Qty. 2
Tank Wire
NOTE: Rear view
of cart. Wheels are
to right side.
27
Qty. 2
(Metal)
NOTE: Front view
of cart. Wheels are
to left side.
5
27
Grill Bottom/
Control Panel
Assembly
Support Bar
Center Hole
Support Bar
Front Hole
Grill Bottom/Control Panel Assembly and Tank Wire
Carefully place grill bottom/control panel assembly onto cart, so as
not to scratch paint on legs. Make sure control panel bracket fits over
support bar on each side.
Insert carriage bolts through grill bottom and center hole in support
bar. Thread metal wing nuts onto bolts but do not fully tighten.
Insert carriage bolts through control panel bracket and front holes in
support bar. Secure with plastic wing nuts.
Fully tighten metal wing nuts.
Insert ends of tank wire into slots on each side of tank hole in base.
Lean tank wire toward midshelf.
26
p/n 4080615
28
p/n 4080074
26
p/n 4080615
28
p/n 4080074 Control
Panel
Bracket