Kenwood DRV-410 Manual

Initial set-up for driver alert function
In order to optimise “Driver Alert Function”, adjustment of “Center Point” and
“Horizon” is very important. to prevent unnecessary audio alerts.
Center Line

Center Point
Horizon
Adjust the installation angle of the device and
then fix the DRV-410 in place.
Turn the angle adjustment knob clockwise before
adjustment. When adjusting the installation angle, check
that the camera field of view is parallel to a level ground
surface and that the ratio of the sky and ground are the
same. After adjusting the installation angle, turn the angle
adjustment knob of the adjustment bracket
counterclockwise to fix the DRV-410 in place
1.
Press the [MENU/OK] button, use the
buttons to align the guideline with the horizon,
and then press the [MENU/OK].
Adjust as shown below
2.
Press the [MENU/OK] button, use the buttons to
align the guideline with the bonnet front edge, and then
press the [MENU/OK].
Adjust as shown below
3.
Press the [MENU/OK] button, use the
buttons to align the guideline with the horizon,
and then press the [MENU/OK].
Adjust as shown below
1.