Keurig K-Mini Plus User manual

Let’s get
brewing.
Quick Start Guide

1.
2. For household use only.
3. Do not use distilled water.
4. Scalding may occur if the handle is
opened during the brewing process.
5. Do not touch hot surfaces. Use handles or
knobs.
6. To protect against fire, electric shock, and
injury to persons do not immerse appliance,
cord, or plugs in water or other liquid.
7. Close supervision is necessary when any
appliance is used by or near children 12 years
or younger.
8. Unplug from outlet when not in use and
before cleaning. Allow to cool before putting
on or taking off parts, and before cleaning the
appliance.
9. Do not operate any appliance with a
damaged cord or plug or after the appliance
malfunctions, or has been damaged in any
manner. The appliance should be returned
to the nearest authorized service facility
for examination, repair, or adjustment if
applicable or contact Keurig customer service.
When using electrical appliances, basic safety precautions should always be followed,
including the following:
10. The use of accessory attachments not
authorized by the appliance manufacturer
may result in fire, electric shock, or injury to
persons.
11. Do not use outdoors.
12. Do not let cord hang over edge of table or
counter, or touch hot surfaces.
13. Do not place on or near a hot gas or electric
burner, or in a heated oven.
14. Always attach plug to appliance first (if not
permanently attached), then plug cord into the
wall outlet. To disconnect, turn any control to
″off″ then remove plug from wall outlet.
15. Do not use appliance for other than intended
use.
16. Use brewer in upright position only. Allow
brewer to cool (90 min) prior to turning it in
any position other than upright.
17. Do not immerse brewer in water.
18.
For detailed brewer cleaning and maintenance
instructions, videos, and the full Use & Care Guide
visit support.keurig.com.

WARNING !
RISK OF FIRE OR ELECTRIC
SHOCK DO NOT OPEN
WARNING, TO REDUCE THE RISK OF
FIRE OR ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE
1. WARNING: Keep all plastic bags away from
children.
2. CAUTION: Keurig® recommends using only
Keurig® My K-Cup® Reusable Coffee Filter
and Keurig® approved K-Cup® pods in this
appliance. The use of non-Keurig® pods or
accessories may cause brewer malfunction or
injury.
3. CAUTION: There are two sharp needles
that puncture the K-Cup® pod, one above
the K-Cup® pod holder and the other in the
bottom of the K-Cup® pod holder. To avoid risk
of injury, be aware of the needle locations.
4. CAUTION: There is extremely hot water under
pressure in the K-Cup® pod holder during the
brew process. To avoid risk of injury do not
lift the handle or otherwise open the handle
during the brew process.
5. POWER CORD INSTRUCTIONS:
a. A short power-supply cord is provided to
reduce risks resulting from becoming entangled
in or tripping over a longer cord.
b. Longer detachable power-supply cords or
extension cords are available and may be used
if care is exercised in their use.
c. If a long detachable power-supply cord or
extension cord is used:
i. The marked electrical rating of the
detachable power-supply cord or extension
cord should be at least as great as the
electrical rating of the appliance.
ii. If the appliance is of the grounded type, the
extension cord should be a Grounding type
3-wire cord.
iii. The longer cord should be arranged so that
it will not drape over the counter top or table
top where it can be pulled on by children or
tripped over.
6. CAUTION: HOT COCOA/OTHER NON-
COFFEE PODS: Immediately after using a
hot cocoa/other non-coffee pod, run a hot
water brew cycle without a pod to avoid the
possibility of clogging the exit needle. DO NOT
assume the next user will do this.

Before You Brew
Power Button
STRONG
3. Place
2. Pour
STRONG
Fill & Place
Add 1 cup (8oz) of water into a mug. Lift the
water reservoir lid and pour the water into the
reservoir. Do not fill past the MAX or below the
MIN fill lines. Lower the lid and place your mug
on the drip tray.
NOTE: Do not use distilled water.
Plug & Power
Remove packing tape from brewer. Pull plug and
extend cord from cord storage located at the
back of the brewer. Plug into a grounded outlet.
Press the power button. The power button will
illuminate.
1. Fill (8oz)

STRONG
STRONG
Brew Button
STRONG
Brew Indicator
Cleansing Brew
Press the brew button. The brew indicator light
will illuminate solid, then begin to pulse while the
brewer is heating. After about 2 minutes, the
brew indicator light will illuminate solid again
and the water will begin to dispense. Pour the
hot water into the sink.
The one-time setup process is now complete
and you are ready to brew!
Lift & Lower
Lift and lower the handle. Do not insert a
K-Cup® pod. The brew indicator light will
flash to indicate that the brewer is ready.

Brew Your First Cup
STRONG
STRONG
3. Place
2. Pour
Lift & Place Pod
Lift the handle. Place a K-Cup® pod in the
K-Cup® pod holder. Lower the handle completely
to close the lid. The brew indicator light will
flash to indicate that the brewer is ready.
Do not remove the foil lid on the K-Cup® pod.
High Altitude Brewing: While holding the brewer handle up,
push down slowly on the K-Cup® pod in the pod holder until
the bottom of the K-Cup® pod is punctured by the exit needle.
Fill & Place Mug
Add desired amount of water into a mug
(6oz minimum, 12oz maximum). Lift the
water reservoir lid and pour the water into the
reservoir. Do not fill past the MAX or below the
MIN fill lines. Lower the lid and place your mug
on the drip tray.
STRONG
Brew Indicator

Brew & Enjoy!
Press the brew button - for bolder coffee, press the STRONG button
before pressing the brew button. The brew indicator light will
illuminate solid, then begin to pulse while the brewer is heating. After
about 2 minutes, the brew indicator light will illuminate solid again
and the beverage will begin to dispense. Brewing is complete when
the brew indicator light is no longer illuminated. When complete, lift
the handle and dispose of the used K-Cup® pod.
CAUTION: While brewing, there is extremely hot water in the K-Cup® pod holder. To avoid injury, do not lift the
handle during the brewing process.
Brewer Features
Strong Brew increases your coffee strength
and intensity. For bolder coffee press the
STRONG button.
Pod Storage holds 9 K-Cup
® pods and fits in
your brewer to save counter space.
Removable Water Reservoir for easy cleaning
and filling.
Auto Off: Automatically turns your brewer
off 90 seconds after the last brew for energy
savings.
Cord Storage: Makes transporting your
brewer convenient and keeps countertops
tidy.
Travel Mug Friendly: Remove the drip tray to
accomodate a travel mug.
Caring for your Brewer
Regular cleaning keeps your brewer running
smoothly. Always be sure to turn off and
unplug your brewer before cleaning. For
detailed brewer cleaning and maintenance
instructions, videos, and the full Use & Care
Guide visit support.keurig.com. Beyond these
recommended cleaning instructions, this
brewer is not user-serviceable. For service,
please refer to the Warranty included with
your brewer.
Water Reservoir
The removable water reservoir should be
STRONG
Brew Button
STRONG

Have questions? We’re here to help. Visit keurig.com/new for troubleshooting
videos, maintenance recommendations, and the full Use & Care Guide.
Still need help? Give us a call at 1-866-901-BREW (2739)
Coffeehouse taste
in your own home.
FIND YOUR PERFECT POD
With over 70 brands and hundreds
of varieties, find your match at
keurig.com/new
cleaned periodically with a damp, soapy, non-
abrasive cloth. Rinse the reservoir thoroughly after
cleaning. This will ensure that no cleaning
solutions remain in the area as they may
contaminate the water supply. Do not dry the
inside of the water reservoir with a cloth as lint
may remain.
Exit Needle
Remove the pod holder assembly
and detach the funnel. Locate
the exit needle on the inside
bottom of the K-Cup® pod holder.
Insert a straightened paper clip
into the exit needle to loosen any
coffee grounds.
Entrance Needle
Lift the brewer handle and locate the entrance
needle on the underside of the lid. To clean both
holes in the needle, hold the brewer handle in the
upward position and with your other hand,
carefully insert a straightened paper clip into
both holes. Gently move it around to loosen any
coffee grounds. Lower the handle completely and
run two water-only brew cycles. Do not insert a
K-Cup® pod.
CAUTION: There are sharp needles that puncture
the K-Cup® pod above the K-Cup® pod holder and
in the bottom of the K-Cup® pod holder. To avoid
risk of injury, do not put your fingers in the
K-Cup® pod holder.
DC0000001254 REV C