Keysight EDU190A User manual

Keysight EDU190A Instrument Stacking Kit
Operating Instructions
This stacking kit is designed for use with Keysight EDU34450A digital multimeter, Keysight EDU33210 Series arbitrary
waveform generator and Keysight InfiniiVision 1000-X Series oscilloscopes.
Parts
A: Stack Cover - Top
5190-9165 (x1)
B: Stack Cover - Bottom
5190-9167 (x1)
C: Stack Cover – Side
5190-9166 (x2)
D: Stack Cover – L Bracket
5190-9168 (x1)
E: M5x10mm Phillips Pan Head Screws
0515-6575 (x11)
F: Pozi Flat Countersunk Self-Taping Screw
0515-6574 (x1)
G: Nylon Plug
0590-3410 (x1)
Tools required: Phillips head screwdriver
Assembly instructions
1. Attach the side stack cover (C) to bottom stack cover (B). Tighten with 2 screws (E) using Phillips head screwdriver.
Repeat the same step for the other side.
2. Put the top stack cover (A) above the assembled item in Step 1, as shown below. Tighten with 2 screws (E) using Phillips
head screwdriver. Repeat the same step for the other side. Ensure all the screws are firmly tighten.

EDU34450-90101
<k
© Keysight Technologies 2020
Printed in Malaysia
December 24, 2020
Application
Single stacking kit
Dual stacking kit
Assembly instructions
Stack up to 2 sets of single stacking kit and tighten with 2 screws (E) at the rear flange.
Install L-bracket (D) to the rear of the stacking kit with one screw (E) and mount it to the wall with self-taping screw (F).