Kickerkult Vector Foosball table User manual
!
Vector Foosball tables
Scope of delivery and assembly instructions
Main box
•1 corpus with integrated playing field and mounted bearings
•2 leg frames
•4 leveling feet, black (Vector 3 and Pro premounted in the leg frame)
Additional box inside
A - 12 carriage bolts with nuts and 8 Phillips screws for leg frame
B - 2 ball slots and 6 Phillips screws
C - 8 playing rods (2 rods with 2 holes, 4 rods with 3 holes,!
2 rods with 5 holes)
D - 8 handles for playing rods
E - 16 rubber bumpers with plastic discs
G - 2 x 11 Soccer playing figures
H - 4 adjusting rings with socket-head screws and locknuts
I - 25 socket-head screws and locknuts for playing figures!
( 3 pieces as spare parts)
J - 2 goal counters with 4 Phillips screws for fastening
L - 2 playing balls
M - 1 lubricant for the playing rods (pure silicone oil without additives)
Ausstellung und Lager Tel. Internet!
Oberau 8 (0 30) www.kickerkult.de!
Seite !1
!
Step 1: Assembling the leg frame and ball slots
Unbox the corpus and place the bottom side on the floor.
Attach each leg frame as shown in mounting position and insert the!
carriage bolts ( A) from the outside.!
Firstly tighten the nuts slightly, then mount the lag frame with the 8 Phillips screws
(A).!
You can screw it in the multilayer wood without prebore.
Now tighten the nuts of the carriage bolts.!
Tighten it carefully and make sure that screw cap does not damage the exterior
decor.
After the lag frame is mounted turn the table with an assistant into standing position.!
!
Lastly mount the ball slots ( B )"
Ausstellung und Lager Tel. Internet!
Oberau 8 (0 30) www.kickerkult.de!
Seite !2
!
Step 2: preparing the playing rods!
!
Fix the handles onto the rods (correct side marked with a single hole) before
mounting them.!
(note: this borehole is only for mounting wooden grips of ancient construction type)!
!
We recommend to moisten the rods with a wet cloth. The aqueous film eases the
mounting of the handles and playing figures in the next step.
Put on the handle ( D ) on the grip end of the rod as far as possible ( C ).!
Now push it as shown perpendiculary on solid ground until the grip is completely in
its position.!
Be careful to avoid that the rod breaks through the handle. You will notice a different
sound the handle makes when it hits the ground.!
"
Ausstellung und Lager Tel. Internet!
Oberau 8 (0 30) www.kickerkult.de!
Seite !3
!
Step 3: Installing the playing rods and goal counters
You can install the rods into the table now. The position of the rods, playing figures,
adjusting rings and the rubber bumpers can be seen in the following illustration.!
(note: At the model „Vector Pro“ the plastic ring ( F ) is not required)!
Goalie-rod All other rods
!
Lastly mount the goal counters (J).
Ausstellung und Lager Tel. Internet!
Oberau 8 (0 30) www.kickerkult.de!
Seite !4
Table of contents
