Kimball Perks User manual

Perks®1 of 2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
2382510 Revision -
Assembly Instructions
Flexchain Cable Manager
Tools Required
Package Contents
• Cordless Drill
• #2 Phillips Screwdriver Bit
• 5/16” Open End Wrench
1. Align two chain segments as shown. (Figure A)
Insert top segment pin into bottom segment hole on one
side. Then gently flex the opposite side out and engage the
opposite pin into the opposite hole.
2. Repeat process until all 17 segments are assembled to
together. (Figure B)
3. Align the floor mount to the bottom segment of the
previously assembled chains. (Figure C)
Insert bottom segment pin into floor mount hole on
one side. Then gently flex the opposite side out and
engage the opposite pin into the opposite hole.
Note: The floor mount has does not secure to the floor.
It has a weight inside it to keep it in place.
4. Align the top mount to the top segment of the previously
assembled chains. (Figure D)
Insert top mount pin into the top segment hole on one side.
Then gently flex the opposite side out and engage the
opposite pin into the opposite hole.
Installation
• (4) 3.5X16mm Pan Head Phillips Wood Screws (for
mounting under worksurfaces)
• (4) 6-32 X .25 Pan Head Phillips Machine Screws (for
mounting under Perks Power Data Drawer)
• (4) 6-32 Hex Nuts (for mounting under Perks Power Data
Drawer)
Figure A
Figure C
Figure B
Figure D
Insert pin into hole
Flexchain after all 17
segments have been
snapped together.
Insert pin into hole
Floor Mount
Insert pin into hole
Top Mount

Perks®2 of 2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
2382510 Revision -
Assembly Instructions
5. For Perks Power Data Drawer:
Position assembled Flexchain top mount under the Perks
Power Data Drawer and align holes. Install four 6-32
machine screws and hex nuts. (Figure E).
Note: The Power Data Drawer has mounting cutouts on both
ends of the drawer.
For under worksurface mounting:
Position assembled Flexchain under the worksurface in
the approximate location desired. This may be under
a grommet or near a wire manager. Install four Pan Head
Phillips Wood Screws as shown. (Figure F)
6. Route cables as needed in cable areas. (Figure G)
Place the cable at the desired opening and gently push
the cable inside the cable area.
Figure E
Figure F
Perks Power Data
Drawer Mounting
4 Nuts
4 Machine Screws
Under Worksurface
Mounting
4 Screws
1/2” x 1 7/8”
Data Cable Areas
2 1/2” x 1 7/8”
Power Cable Area
Figure G
Data Cable
Push
Power Cable
Push
Data Cable
Push