KingTone Switch User manual

VOLUME POT
White
Red
Black
Add the White, Red and Black wires to the volume pot as shown.
KINGTONE SWITCH INSTALLATION
1. Solder the Kingtone Switch as shown in the diagram.
2. Reassemble the guitar, but leave the Kingtone switch on the outside of the guitar.
5. Remove plastic protector tape from the slide switch.
4. Make adjustments to the treble bleed settings until you’re happy.
5. Open the guitar back up and tightly install the Kingtone Switch with washer and nut.
If installing the Kingtone Switch on a Strat guitar, we recommend using the remaining tone
pot to control either all pickups or just the middle and neck.
Use the wire taken from the middle leg of the old tone control and add
it to the remaining tone control’s middle leg and solder in place.
PLEASE CHECK OUT THE KINGTONE SWITCH INSTALLATION VIDEOS
www.kingtoneguitar.com/instructions
Install The Kingtone Switch As Follows

1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4 1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
SMITH
LAWRENCE
MOJO
J.S.
FENDERY
DUNCAN
KINGTONE
KINGTONE SWITCH SUGGESTED SETTINGS
LINDY
SUPER BITE
KIN
SUBTLE
ENHANCE
RESTORE
BYPASS