Kirk 1G8 User manual

KIRK Base Station
1.8 GHz
User Guide

1 Introduction
The base station is only intended for use with a
wireless server. The base station is not intended to
be connected directly to the PSTN network. The
base station is designed with two internal antennas
and supports antenna diversity. The base station is
also able to carry out a handover between the RF
channels under the same base station, and handles
four DECT speech channels simultaneously. The
base station is able to frame synchronize with other
base stations under the same wireless server.
Transmission lenght is up to 2 km/1.2 miles on a
twisted pair, e.g. cat.4, between the base station and
wireless server. The base station is also power sup-
plied from this connection (maximum supply 1.5
W). The DECT radius of coverage is up to 600
meters/1960 feet with a handset in free sight.

2 Installation
First you have to determine where to install the base
station to have the right coverage. The average cov-
erage within buildings is 75 meters/246 feet. The
coverage depends on the construction of the build-
ing, architecture and choice of buildings materials.
You may have to use the Deployment Kit to opti-
mize your installation.
The base station is to be mounted directly on the
ceiling.
Note: If necessary, the base station can hang from
a wire attached to the ceiling, either alone or in
clusters with at least 25 cm/10 inches between each
base station. The wire is attached to three holes at
the top of the base station.

Mounting ring Release spring

To mount the base station directly on the ceiling:
1Pull the cable through the mounting ring, and
then mount the mounting ring on the ceiling,
using the anchors and screws accompanying
the product.
2Connect the plug to the top of the base station.
Adjust the length of the cable.
3Click the base station onto the mounting ring.
Note: If you need to remove the base station, sepa-
rate it from the mounting ring with a gentle push of
a screwdriver on one of the release springs.

4After the wireless server is powered up again, a
cable lenght measurement is needed.
Note: Cable dimensions min. as AWG 26.

International Regulatory Information
Please find the EC Declaration
of Conformity at
http://www.kirktelecom.com/
company/suk273.asp
The WEEE Marking on this
equipment indicates that the
product must not be disposed of
with unsorted waste, but must be
collected separately.

KIRK telecom A/S
Langmarksvej 34
DK-8700 Horsens
Tlf. [phone]
Fax [phone]
www.kirktelecom.com
1415 4900-HD, ed.1.