Kitchensource SP36 User manual

Installation Manual For Shower Door
V01
Code:SP36
READ THE INSTRUCTIONS CAREFULLY, familiarize yourself with all the parts as shown
in the exploded view. The exploded view will also provide a helpful reference when relating
to the location of the various parts and how they are mounted.

Exploded diagram
Tools required
1/5

Step:1 Step:2
Drywall Wall finish (tiles)
Silicon
Place the shower tray where desired.Use a level
to make sure the tray is in horizontal position.
Apply silicon sealant to shown the position.
Make sure distant A is 15-20mm.Use a level,
plumb the wall jamb(NO.2)
and mark the 3 wall mounting holes.
Repeat for the other wall jamb.
Step:3
Drill a hole at each marked
location with a Ф6-8mm drill bit,
after using pencil to mark the
mounting holes.Then fix the 2
wall jambs with 4*35 screws
(NO.1).
use pencil to mark the
mounting holes
15-20MM
A

Step:4
Step:5
3/5
Assemble upper and bottom track.Then connect the side panel(NO.3) with the
upper and bottom track,finally insert the shower enclosure to wall jamb.
Roller assemble

Step:6
Step:7
4/5
Drill the hole with mm drill bit, then tighten the screw. Ф3
Hang the movable doors on the track.

Step:8
Step:9
5/5
Apply silicon sealant to the position shown as the diagram,install the gasket(NO.8)
and magnetic seal(NO.15) on the movable door.
Install the handles(NO.16) on the door, do not use the shower
enclosure within 24 hours after applying the silicon sealant.