RF-15
SPECIFICATIONS
BANDWIDTH 46Hz-20kHz ±3dB
SENSITIVITY 96dB @ 2.83 volts/1 meter
NOMINAL IMPEDANCE 8 ohms compatible
CROSSOVER FREQUENCY 2350Hz
POWER HANDLING 100 watts (400 watts peak)
ENCLOSURE TYPE Bass-reflex via rear-firing port
DRIVE COMPONENTSTwo way system using one 1'' (2.5cm)
magnetically shielded, titanium dome
compression driver with an integral 5''
(12.7cm) square 90˚x 60˚ Tractrix Horn and
two 5.25'' (13.3cm) magnetically shielded,
Cerametallic cone woofers
WEIGHT 37 lbs. (16.8kg)
HEIGHT 36.9" (93.7cm) w/feet, 36'' w/o feet
WIDTH 6.8" (17.3cm)
DEPTH 12.8'' (32.5cm)
FINISH Black Ash or Light Cherry woodgrain vinyl
■Very high sensitivity and power handling
■Tractrix Horn titanium dome compression driver tweeter for clean,
detailed highs
■Cerametallic cone woofers with cast-polymer frames
■Bi-wire compatible inputs
■Magnetically shielded to prevent video interference
Dual 5.25'' Two-Way Floorstanding Loudspeaker
The RF-15 offers tremendous value and
versatility in a high-performance floorstanding
loudspeaker. Slender and compact, it still has
the efficiency, power handling, and bass
extension to deliver a potent sonic wallop. The
RF-15 works equally well standing alone in
a stereo music system or fronting a
sophisticated home theater. And because it is
perfectly matched cosmetically and sonically to
the other Klipsch Reference Series
loudspeakers, it allows terrific flexibility in
system configuration.
The RF-15 uses a 1-inch titanium-dome
compression driver tweeter for the high
frequencies, loaded by a 5-inch square 90° x
60° Tractrix®Horn molded into the front of
the enclosure. The horn raises the driver’s
efficiency and controls its radiation pattern to
minimize detail-blurring reflections from walls,
floor, and ceiling. Dual 5.25-inch
Cerametallic™cone woofers with rigid, low-
resonance cast-polymer frames generate
dynamic, room-filling bass. All drivers are
magnetically shielded to prevent interference
with direct-view television sets.
Amplifier connections are via two pairs of
binding posts, which are strapped together for
normal wiring. Removing the straps allows the
speaker to be bi-wired. Magnetic posts hold
the RF-15’s low-diffraction grille securely in
place, and the outrigger feet can be fitted with
adjustable-height rubber pads or spikes. The
rear-ported cabinet is available in a Black Ash
or Light Cherry woodgrain vinyl finish.
www.klipsch.com
1-800-KLIPSCH
All specifications are subject to change without notice. ©2004
