KLOBER CIELLO User manual

Operators manual
CIELLO
Office swivel chair for
VDU-workstations
and desk-workstations

2
CIELLO Operating System
whilst seated left whilst seated right
Air-Support
Depth-adjustment
Locking of
Synchro-
mechanism Seat height
adjustment
Body weight
adjustment

„Air-Support“
height adjustment
lumbar support
3

4

5
Seat height adjustment
Your chair can be height-adjusted from 40 to 53 cm using
a safety gas spring.
Pull the lever under the front right of the seat up and
the seat height can be adjusted. Release the lever and
the seath height is fixed.
You are sitting correctly when your thigh and calf form
an angle of 90°.

6

7
Bodyweight adjustment
The correct setting of the seat back pressure according
to your body weight is very important.
This needs to be set so that yout back is well supported
in every sitting position, without the backrest being too
light or too hard.
Your Ciello has a practical quick-adjustment system for
the bodyweight setting. Adjustment is made using the
lever in the middle under the right hand side of your
seat.
Attention: please only use the weight adjustment lever
when the backrest is in an upright position!
The lever is pulled out and then turned downwards to
increase the weight setting and turned upwards to
decrease the setting (120 kg – 45 kg).

8

Locking of the sitting position
From an ergonomical point of view, it is adventageous
to have continously changing sitting positions whilst
working (dynamic seating).
However, if required, you can lock the mechanism in pla-
ce and thereby temporarily disable the synchro motion.
To do this move the lever under the front of the left hand
side of the seat downwards – the mechanism is now
locked. To release, move the lever back up to its original
position. There are three locking positions: forward,
middle and rear.
9

10