KLOPFENSTEIN AA300L-R Datasheet

ASSEMBLY INSTRUCTIONS & PARTS LIST FOR THE
KLOPFENSTEIN ART TABLE WITH OPTIONAL ROTATOR (AA300L-R)
Step 1: Fit Center
Upright onto base
as shown.
Step 2: Tighten upper
then lower set bolts back
and forth uniformly until
everything is tight, tight!
Need Help? Call us at 419-884-2900 with questions or comments.
Pivot Bracket
Locking Knobs
Pivot Bracket Bolt,
Locknut & Washers
Set Bolts to Lock
Center Upright Onto
Base
Lever Handle Locks
Telescoping Upright
Your table top with optional
rotator is heavier than our
normal tops without the
rotator. To compensate for
the extra weight we have
added an extra half length of
spring inside the Center
Upright. The extra half spring
and the full spring are
already inside the upright.
The full spring is stacked
on top of the half spring
with the factory finished
end of the half spring up
and the cut off end down.
Your springs will work better
if you keep them stacked this
way.
A few inches of
the spring will
protrude from
the top of the
upright.
Step 3: Attach the telescoping
upright to the pivot bracket with
the pivot bracket bolt, washer and
locknut. Screw in the pivot bracket
locking knobs and insert the
upright into the assembled base
unit. Screw in lever handle.
Tighten the pivot bracket bolt
& nut until there is enough
resistance that the top will not
unexpectedly fall forward or
backward when the locking
knobs are loosened to adjust
tabletop tilt angle. Do not
over tighten, making it difficult
to make tilt adjustments.
PARTS:

ADJUSTING THE OPTIONAL ROTATING ART TABLE TOP FOR
HORIZONTAL OR VERTICAL WORK
Need Help? Call us at 419-884-2900 with questions or comments.
Spring loaded steel plunger locks rotating
top into a vertical or horizontal orientation.
Pull out on plunger knob to rotate top.
Round locking knobs
control tabletop tilt
angle.
Rear View Horizontal
Orientation
Rear View Vertical
Orientation Top in Horizontal Orientation
& Tilted 30° From Vertical
An easy way to
adjust the tabletop
height, and rotate it
to a vertical or
horizontal orientation
is to first pivot the
top straight up and
down as shown here,
and then make your
rotation & height
adjustments.