Knapheide DW42-6: DW42-10: DW44-6 User manual

KNAPHEIDE VAN EQUIPMENT INSTALLATION INSTRUCTIONS
DRAWER KITS DW42-6, DW42-10, DW44-6 & DW44-10
DOCUMENT # 68298-01
This document must not be copied or communicated to a third party without the expressed
authorization of The Knapheide Manufacturing Company.
FOR REF ONLY
Printed copies are uncontrolled.
PARTS
QTY PART # DESCRIPTION
1 Drawer of Choice
1 33897276 Drawer Slide 040 132 lb Left
1 33897277 Drawer Slide 040 132 lb Right
4 33897088 M6x10 Fillister HD Screw
4 33897091 Sprung Nut Plastic / ESMK
The 42-6 and 42-10 Drawer Kits can be mounted on all Wide-2
Shelf Staxx. The 44-6 and 44-10 Drawer Kits can be mounted
on all Wide-4 Shelf Staxx.
NOTE: For both height 6 and 10 drawers, the telescopic slide
will always be mounted at the 3rd hole up in the desired space.
NOTE: The telescopic slides are manufactured with a variety
of tabs. Each set of tabs serves a di󰀨erent purpose. Drawer
Suspension Tabs are meant to t into notches in the body of the
drawer itself. Slide Mounting Tabs are connected to the Shelf
Staxx end panels.
NOTE: Prior to installing drawers or other accessories, be sure
to allow enough room for the drawer to t under or between
other Staxx components. Drawers require 6 or 10 grid spaces
regardless of drawer width.
Minimum Required Spacing
Drawer Holes
42-6 & 44-6 6
42-10 & 44-10 10

KNAPHEIDE VAN EQUIPMENT INSTALLATION INSTRUCTIONS
DRAWER KITS DW42-6, DW42-10, DW44-6 & DW44-10
DOCUMENT # 68298-01
This document must not be copied or communicated to a third party without the expressed
authorization of The Knapheide Manufacturing Company.
FOR REF ONLY
Printed copies are uncontrolled.
After securely fastening the slides to the end panels, fully ex-
tend both slides and lower the drawer between the slides and
onto the suspension tabs. Be sure to line up the 4 slots on the
sides of the drawer with the 4 drawer suspension tabs-make
sure all tabs protrude through the slots. Push down and pull out
on the drawer so that it is fully seated on all suspension tabs on
both telescopic slides.
NOTE: When installed on the correst side, the drawer suspen-
sion tabs point UP.
Determine the desired location for the Drawer Kit.
Fasten drawer slides to the Staxx end panels using the sprung
nuts and M6 x 10 screws. Insert the sprung nuts into the slide
mounting tabs. Then insert the M6 x 10 screws from the outside
of the end panel into the sprung nuts and tighten. Repeat on
both sides.
NOTE: Failure to mount the telescopic slides parallel will lead
to misalignment of the drawer.