knead KC01 User manual

KC01
Ergonomic Office Chair
- USER GUIDE -
SEAT HEIGHT: Back tab, right side of chair
Tip: Adjust your chair such that your knees form a 90 degree
angle, and your thighs are roughly parallel to the ground. If
your chair doesn't go low enough, a foot rest can help bridge
the gap.
SEAT DEPTH: Front tab, right side of chair
Tip: Adjust your seat forwards or backwards and allow for
2"-3" from behind the knee to the front edge of the seat. Make
sure you're sitting all the way into the back of the chair, with
To raise seat:
Pull the tab and lift your
weight to raise the seat
height.
To lower seat:
While seated, pull the tab
and lower seat.
To increase or decrease depth:
Pull the tab on the front right of your chair to disengage
the locking seat depth adjustment. Slide seat forward or
back into proper depth for use; then release the tab to lock
the seat.
SEAT HEIGHT SEAT DEPTH
RECLINE TENSION BACK LOCK
RECLINE RENSION: Front tab, left side of chair
Tip: Set the tilt tension to control the amount of resistance you
feel when leaning back.
BACK LOCK: Back tab, left side of chair
To increase the
recline tension, slide
the tab towards the
center of the chair.
To reduce the recline
tension, slide the tab
towards the outside of
the chair.
To lock the back of the chain:
Pull the tab on the back left of your chair to lock the
backrest into one of three positions, from upright to fully
reclined. To disengage the back lock, push the tab in and
lean back on the chair lightly until you hear a click,
signalling the back has been released.

knead
kneadfurniture.com
LUMBAR HEIGHT
Tip: Adjust the lumbar height so that it comfortably supports
the natural curve of your spine.
To raise or lower lumbar support:
Move back lumbar support up or down as
needed by holding the handles behind each
lumbar pad.
LUMBAR HEIGHT
ARM ADJUSTMENTS
To adjust arm height:
Squeeze lever on the front of the arm stem while pulling
arm up to raise arm to desired height. To lower arm,
squeeze lever on arm stem while pushing arm down on
armpad.
Tip: For maximum comfort, your arms should make
contact with the armpad without any lift at your
shoulders.
To adjust arm angle:
Grasp armpad and pivot in or out.
Tip: Adjust arm angle inward when using a keyboard;
adjust arm angle outward when using a mouse.
To adjust arm width:
Grasp armpad to pull in or push out.
Tip: Armpad width is properly adjusted when your elbows are in line
with your shoulders while seated.
To adjust arm depth:
Grasp armpad and slide forward or backward.
Tip: Adjust for comfort. Avoid any pressure on wrists and elbows.