Knightsbridge SKR008 Instruction Manual

11
INSTALLATION & MAINTENANCE MANUAL
SKR008 / SKR009A
230V
50Hz
IP
20
1

These instructions should be read carefully and retained after installation by the end user for future
reference and maintenance.
These instructions should be used to aid installation of the following products:
SKR008 / SKR009A
GENERAL INSTRUCTIONS
SAFETY
INSTALLATION
• Installation of this product should only be carried out by a qualified electrician or competent person
to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this product is fitted) does not exceed the rating
of the circuit cable, fuse or circuit breaker
• This product is Class I and must be earthed
• For indoor use only
• Do not subject product to insulation resistance testing
• Provide power to the required point of installation
• Remove the two screws on the front plate to remove the plate (see Fig 1)
• Mark the location of the fixing holes and drill the holes ensuring not to infringe with any joists,
gas/water pipes or electrical cables (see Fig 2)
•
•
•
Remove screws
•
•
•
Screw mounting locations
Cable entry
gland
Fig 1
Fig 2
2

• Feed through mains cable via the cable entry gland (see Fig 2)
• Connect Live (brown), Neutral (blue) and Earth (green and yellow) to the 3-way terminal block
(see Fig 3)
• Reconnect face plate with the 2 screws
• Put the screw covers over the screws
• Switch on power supply and check for correct operation
WARNING
GENERAL
WARRANTY
The SKR009A version must be disconnected from the circuit if subjected to any high voltage or
insulation resistance testing. Irreparable damage will occur if this instruction is not followed.
The product should be recycled in the correct manner when it reaches the end of its life. Check local
authorities for where facilities exist.
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may
damage the fitting.
This product has a warranty of 1 year from date of purchase. Failure to install this product in
accordance with the current edition of the IEE Wiring Regulations, improper use, or removal of the
batch codes will invalidate the warranty. If this product should fail within its warranty period it should
be returned to the place of purchase for a free of charge replacement.
ML Accessories does not accept responsibility for any installation costs associated with the
replacement product. Your statutory rights are not affected. ML Accessories reserve the right to alter
product specification without prior notice.
Fig 3
•
•
•
•
Neutral
(blue)
Live
(brown)
Earth
(green/
yellow)
3

SBMAY18_V1
ML Accessories Group Limited
LU5 5TA
www.mlaccessories.co.uk
4