KNOP RP902 User manual

KNOP ELEKTRONIK A/S
Fabriksvej 20 DK-7600 Struer  kn[email protected]k www.knop.dk [phone]
THIS USER GUIDE APPLIES FOR SOFTWARE VERSION 1.X
User guide for
RP902

KNOP ELEKTRONIK A/S
Fabriksvej 20 7600 Struer  [e-mail] www.knop.dk [phone]
2
Table of contents
Installing ............................................................................................................................................................................ 3
The LED .............................................................................................................................................................................. 3
Backup ............................................................................................................................................................................... 3
Setup .................................................................................................................................................................................. 3
Buttons .............................................................................................................................................................................. 4
Maintenance ...................................................................................................................................................................... 5
Technical data RP902......................................................................................................................................................... 6

KNOP ELEKTRONIK A/S
Fabriksvej 20 7600 Struer  [e-mail] www.knop.dk [phone]
3
Intended use
The RP902 is a repeater unit for our Master Repeater system.
This RP902 unit will extend the range of the system. Up to 14 repeaters can be added to a system.
The RP902 has no standalone functions, it will only work if a Master unit is present.
Installing
The RP902 just needs to be plugin a mains outlet (230V). No wires between the units are needed.
The unit will automatically power on when being connected to mains.
The LED
The LED is either green or red when turn on.
RED: Failure, not connected
RED flash: Battery mode.
GREEN: Connected and OK.
GREEN flash: Reply confirmation.
No light: The unit is off.
Backup
The RP902 has an internal backup battery, keeping the system running if power failure. The battery will last for some
hours. If needed the battery will recharge (fully charge approx. 24 hours).
The battery is not for intended for used replacement, please contact your dealer for battery service.
Setup
Before using the RP902 is needs to connected to the system. This is done in the MR902 unit. Please refer to MR902
user manual on how to do this.

KNOP ELEKTRONIK A/S
Fabriksvej 20 7600 Struer  [e-mail] www.knop.dk [phone]
4
Buttons
The RP902 has four buttons primary these are for future use. However, F4 is for powering off the unit typically
before shipping or longtime storage.
Power off: Remove RP902 from mains when press and hold F4 for approx. 5 seconds until it flashes RED.

KNOP ELEKTRONIK A/S
Fabriksvej 20 7600 Struer  [e-mail] www.knop.dk [phone]
5
Maintenance
Software updates
It is possible to update the software in the MR902. For a more detailed description, please refer to KNOPtool.
Cleaning
The product can be cleaned with a damp cloth or alcohol wipe.
Disposal
The product must not be disposed of with household waste. Please refer to local rule regarding disposal of
electronics.

KNOP ELEKTRONIK A/S
Fabriksvej 20 7600 Struer  [e-mail] www.knop.dk [phone]
6
Technical data RP902
Operating voltage: 240VAC
Connector plug: 2-pol EURO
Battery operating time: Approx. 4 hours.
Charging: Approx. 1 day.
Frequency: 869.2125MHz & 862-868.6Mhz
Range: Up to 500 m between MR902/RP902 and RP902 in free air *)
Range within a building: Recommend distance between repeater units <25m.
Surrounding environment: Indoor use. <90% humidity non-condensing.
Ambient temperature: 0-40 ° C
Enclosure type: White ABS
Cabinet dimensions: Ø110mm x 52mm.
Density: IP40
Weight incl. Batteries: 135g
We reserve the right to make changes.
*) Measured outdoors with free visibility between transmitter and receiver.
In buildings, the range can be reduced.
Check the coverage area as described in the relevant section.
We reserve the right to make changes.
Usermanual-RP902-V1.0-UK.docx