Safety Instruction
When using appliance, basic safety precautions should always be followed:
1. Check that the voltage indicates on the data plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
2. This appliance is not intended for use by persons ( including children ) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
3. Children should be supervision to ensure that they do not play with the appliance.
4. If the supply cord is damaged, it must be replaced by a qualified engineer on order
to avoid hazard.
5. The appliance must not be located immediately below a socket outlet.
6. Keep furniture, curtains and other flammable material at least one meter away
from the appliance.
7. Keep out of reach of children and do not allow them to operate this appliance.
8. Do not operate this appliance after a malfunction or after being dropped or
damaged in any way.
Cleaning:
⚫Turn heater OFF and unplug from electrical outlet before any cleaning or
maintenance is performed. Wait at least 10 minutes to allow all components to
cool properly.
⚫Use a vacuum or duster to keep heater and vent area clean from dust and dirt.
⚫The exterior of the fireplace should be cleaned with a damp cloth or duster.
Do not use abrasive cleaners or liquid sprays.
-5-
WARNINGS AND CAUTIONS
WARNING To avoid electrical shock not open the back panel of the insert
unless the Power has been turned off. And the insert has been unplugged.
WARNING Any electrical repairs.to this electric fireplace. Should only be
Performed by a qualified technician.
WARNING Any electrical wiring repairs should only be performed by a
qualified Technician.And also must comply with local buildings codes.
WARNING Discontinue use of this electric fireplace if any of the follow has
Occurred: Water damage. If insert has been or dented. If power
cord has Become broken. If power cord becomes hot to touch, if unit smokes or Smells
like smoke.
Note: When the heat functions is used for the first time.A slight odor may be
Present. This is normal and should be occur again unless heater is not
used For extended periods of time and dust is allowed to accumulate on heater
Element.
Technical Specification
Supply: 120V-60Hz
Rated power:1500W
-6-