MATERIALS:
Thermoformed high-density polyethylene. Mounting instructions and hardware included.
Graphics and safety messages in six languages. Contoured Changing surface area is 379 sq. in
(2445 sq. cm) comes complete with nylon safety straps.
OPERATION:
For use in restrooms where counter space is more abundant than wall space. High-density
polyethylene has no sharp corners, is easy to clean and resists odors and bacterial growth.
Warning: To ensure that the unit supports the intended loads, baby changing stations must be
properly installed according to the manufacturer’s instructions
SPECIFICATION:
Baby changing station shall be durable, high impact polyethylene body. Design of unit shall be
countertop surface mounted. Bed shall have smooth concave changing area with a nylon safety
strap and universal instruction graphics. Unit shall be backed by manufacturer’s 5-year limited
warranty on materials and workmanship and include a provision for replacement caused by
vandalism. Unit shall be manufactured in the U.S.A.
INSTALLATION:
To ensure proper installation and compliance with building codes, it is recommended that a
qualied person or carpenter perform the installation of the unit.
Drilling holes and mounting the station:
1. Remove the station from the shipping container and check for any freight damage.
Identify the best location for installing the baby changing station.
2. Place the countertop Baby Changing Station onto the counter surface and place into
desired position. Using the countertop Baby Changing Station mounting holes as a guide, mark
the screw hole locations with a pencil. Remove countertop Baby Changing Station and drill holes
with a 5/32” (4 mm) drill bit. Drill down ¾” (18 mm) deep.
3. Apply a suitable water sealant, such as silicone, around the bottom edge of the
changing station, then set unit onto the countertop using the mounting holes as a guide. Fasten
unit to counter top with supplied screws.
Caution:
Drill carefully through ceramic tile and other hard counter top materials.
Replacement Parts: For a list of replacement parts for this product (such as straps and labels),
please visit koalabear.com. Replacement parts and additional liners can be purchased from your
local distributor or direct from Koala at koalabear.com.
The illustrations and descriptions herein are applicable to production as of the date of this
Technical Data Sheet. The manufacturer reserves the right to, and does from time to time, make
changes and improvements in designs and dimensions without notice.
Koala Kare Products ǁ6982 S Quentin St. ǁCentennial, CO 80112 Toll Free: 888.733.3456 ǁ303.539.8300 ǁFax: 303.539.8399
www.koalabear.com
®
KB112-01CT TDS June 2020
