Kodak PHOTO GEAR TRIPOD + MONOPOD User manual

1
User Guide
TRIPOD + MONOPOD
70"/ 178 cm
KODAK PHOTO GEAR

INTRODUCTION
SAFETY PRECAUTIONS
PACKAGE CONTENTS
ABOUT THE KODAK 70" / 178 CM TRIPOD + MONOPOD
PRODUCT OVERVIEW
TECHNICAL SPECIFICATIONS
WARRANTY INFORMATION
GET IN TOUCH
1
2
3
4
5
6
7
8
TABLE OF CONTENTS
1
1
2
2
38
9
910
10
TO SEE THIS GUIDE IN FRENCH, ITALIAN,
GERMAN, OR SPANISH, PLEASE VISIT
WWW.KODAKPHOTOPLUS.COM
OR USE THIS QR CODE:
Um diese Anleitung auf Französisch, Italienisch, Deutsch oder Spanisch zu lesen, besuchen
Sie bitte www.kodakphotoplus.com oder nutzen Sie diesen QRCode. | Per visualizzare questa
guida in francese, italiano, tedesco o spagnolo, si prega di visitare www.kodakphotoplus.com,
oppure di usare questo codice QR. | Para ver esta guía en francés, italiano, alemán o español,
por favor, visite www.kodakphotoplus.com o use este código QR. | Pour consulter ce guide en
anglais, en italien, en allemand ou en espagnol, veuillez aller sur le site www.kodakphotoplus.
com ou utiliser ce code QR.

1
INTRODUCTION
Thank you for purchasing the KODAK 70"/ 177 cm 2-in-1 Tripod + Monopod. This User
Guide is intended to provide you with guidelines to ensure that operation of this
product is safe and does not pose risk to the user. Any use that does not conform to
the guidelines described in this User Guide may void the limited warranty.
Please read all directions before using the product and retain this guide for reference.
This product is covered by a limited one-year warranty. Coverage is subject to limits
and exclusions. See warranty for details.
SAFETY PRECAUTIONS
1. WARNING: CHOKING HAZARD – Small parts. This product contains small parts and
is not suitable for children under 3 years old.
2. Remove all packaging before using this device. Please keep all packaging materials
out of reach of children and pets.
3. Properly dispose of all packing materials immediately after unpacking product, as
the bags used for packaging could present a suocation or choking hazard.
4. Read all instructions carefully before attempting to operate this device. Improper
usage could result in a reduction in eicacy.
5. Please take care when extending and folding this unit to avoid damage through
rough handling.
6. Ensure that all knobs, latches, and levers are in their fully locked positions before
using this unit with a camera.
7. Do not attempt to move this unit while the camera is attached. First, take the
camera o, then move the unit before replacing the camera.
8. Do not attempt to oil or lubricate any of the parts of the tripod. Doing so may cause
damage and void the warranty.
9. Do not store this unit in environments with high temperatures.
10. Do not use during lightning storms.
11. Do not sit or ride on the tripod or allow others to do so, as this may cause injuries
as well as damage to the product.
12. Do not use harsh chemicals for cleaning this product; use only a mild detergent
and soft cloth, and dry well before storing.

2
PACKAGE CONTENTS
• 70"/ 177 cm 2-in-1 Tripod + Monopod
• 2 Quick-Release Plates
• Smartphone Adapter
• 1/4" to 3/8"(0.6 cm to 0.95 cm) Screw Adapter
• Carry Case
• Access to free KODAK Tripod/Monopod EGuide
• User Guide
ABOUT THE KODAK 70"/ 178 CM TRIPOD + MONOPOD
• Unique 2-in-1 design delivers a tripod with an integrated monopod
• Tripod + Monopod has fully adjustable 4-section legs, removable Center
Column converts to a 5-section monopod, and 3-way swivel pan head
is included.
• Two (2) quick-release plates included that allow you to switch cameras
without the need to unscrew the plate.
• 1/4"to 3/8"(0.6 cm to 0.95 cm) screw adapter
• 3-way head allows camera to tilt and pan freely to capture stunning images
• Telescoping, liplock leg system allows for a wide range of heights
• Sturdy yet lightweight ABS and aluminum construction keeps your
camera secure
• Rubberized swivel feet keep the tripod safely in place
• Folding center column handle
• Locking aluminum center spreader for maximum stability
SCAN THE QR CODE BELOW WITH
YOUR SMARTPHONE TO DOWNLOAD THE
FREE KODAK TRIPOD/MONOPOD E-GUIDE!

3
PRODUCT OVERVIEW
1. Quick-release lever
2. Monopod
3. Monopod locking knob
4. Foam grip
5. Hook
6. Center brace locking ring
7. Rubber foot
8. Leg locks
9. Folding center column handle
10. Swivel pan head handle
11. Camera mount platform tilt knob
12. Vertical tilt locking handle
13. Horizontal pan locking knob
14. Quick-release plate
15. Mounting screw

4
PRODUCT OVERVIEW (CONTINUED)
1. Adjustable Legs
a. Unlatch the leg locks at the bottom of the leg.
b. Pull out the sections of the leg until it reaches your desired length.
c. Use the center brace locking ring to adjust the center portion of the
tripod up and down to maximize stability.
d. Use the built-in level to ensure the tripod is positioned properly.
e. Re-latch the locks once you have the legs conigured as you wish.
2. Center Column/Removable Monopod
a. Loosen the center column locking knob to adjust the height or remove
the monopod for separate use.
b. If adjusting tripod height, pull out until you reach your desired length
(never pulling past the “Stop Here” mark).
c. Tighten the center column locking knob to secure it in place.
d. The removable monopod provides a lightweight, portable option for
extra versatility.

i.
ii.
iii.
iv.
v.
5
e. To adjust the central column/monopod:
i. Hold the central column/monopod in one hand and grasp the
bottom with the other.
ii. Turn the bottom a quarter-turn to the left and extend the section.
The full column may extend all at once, in which case you can
skip step iii and proceed to step iv.
iii. To increase the length, twist the extended section another
quarter-turn to the left and pull the next section out. Repeat this
process until the monopod is extended to the necessary height.
iv. Turn any extended section to the right to securely lock it into
position. You can lock a section into place at any length; it does
not need to be fully extended to lock.
v. To collapse, reverse the process by turning each section to
the left to unlock it, and then pushing in until the unit is
fully collapsed.

6
3. 3Way Swivel Pan Head
a. 1-Way - To adjust the vertical tilt of the camera mount plate:
i. Loosen the vertical tilt handle.
ii. Adjust to the desired angle.
iii. Tighten the vertical tilt handle.
b. 2-Way - To adjust the horizontal pan of the camera mount plate:
i. Loosen the horizontal pan knob.
ii. Pan right and left to the desired position.
iii. Tighten the horizontal pan knob.
c. 3-Way - To adjust the tilt of the camera mount platform:
i. Loosen the camera mount platform tilt knob.
ii. Adjust the platform to the desired angle.
iii. Tighten the camera mount platform tilt knob.
i.
ii.
iii.
i.
ii.
iii.
i.
ii.
iii.

i. ii. iii.
7
4. Mounting a Camera
a. Pull the quick-release lever on the side of the head to release the plate.
b. Align the screw adapter with the corresponding threading on your camera.
c. Holding the camera in one hand, rotate the plate to the right until it is
securely attached to the camera.
d. Place the camera mount plate back into position.
e. Push the quick-release lever back into the locked position.
f. To remove your camera:
i. Remove the quick-release plate.
ii. Unscrew the plate from the camera.
5. Hook
a. To increase the tripod’s stability, you can hang a sandbag or similar weight
from the hook.

8
6. Mounting a Smartphone
a. Align the screw adapter with the corresponding threading on the
smartphone adapter.
b. Holding the smartphone adapter in one hand, turn the thumb wheel
to the right until it is securely attached to the adapter.
c. You may now pull up on the smartphone adapter clamp and insert your
smartphone in landscape mode.
d. To remove the smartphone adapter, hold it in one hand and turn the
thumb wheel to the left until it is no longer attached.

9
TECHNICAL SPECIFICATIONS
TRIPOD
Materials: Aluminum / ABS
Maximum Height: 70"(177.8 cm)
Minimum Height: 21.5"(54.6 cm)
Folded Length: 22"(55.9 cm)
Weight Capacity: 8.8 lbs. (4 kg)
Tripod/Monopod Weight: 3.7 lbs. (1.7 kg)
MONOPOD
Materials: Aluminum / ABS
Maximum Height: 64.5"(163.8 cm)
Minimum Height: 17.5"(44.5 cm)
Folded Length: 17.75"(45.1 cm)
Weight Capacity: 8.8 lbs. (4 kg)
Tripod/Monopod Weight: 1.0 lbs (0.45 kg)
WARRANTY INFORMATION
LIMITED WARRANTY ON KODAK 70"/ 178 cm 2-IN-1 TRIPOD + MONOPOD
THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY
ALSO HAVE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE.
WE WARRANT THAT DURING THE WARRANTY PERIOD, THE PRODUCT WILL BE
FREE FROM DEFECTS IN MATERIALS AND WORKMANSHIP.
LIMITATION OF LIABILITY
TO THE EXTENT NOT PROHIBITED BY LAW, THIS WARRANTY IS EXCLUSIVE AND
IN LIEU OF ALL OTHER WARRANTIES, ORAL, WRITTEN, STATUTORY, EXPRESS
OR IMPLIED. EXCEPT FOR THE EXPRESS WARRANTIES CONTAINED IN THIS
LIMITED WARRANTY STATEMENT AND TO THE EXTENT NOT PROHIBITED BY LAW,
WE DISCLAIM ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, STATUTORY
OR OTHERWISE, INCLUDING WITHOUT LIMITATION, THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. SOME STATES
DO NOT ALLOW DISCLAIMERS OF IMPLIED WARRANTIES, SO THIS DISCLAIMER
MAY NOT APPLY TO YOU. TO THE EXTENT SUCH WARRANTIES CANNOT
BE DISCLAIMED UNDER THE LAWS OF YOUR JURISDICTION, WE LIMIT THE
DURATION AND REMEDIES OF SUCH WARRANTIES TO THE DURATION OF THIS