Kogan Estelle ESSPAFCSTMA User manual

3-IN-1 SPA FACIAL STEAMER
HUMIDIFIER
(200ML)
ESSPAFCSTMA

Read all instructions before use. Retain this user guide for future reference.
Read the following safety advice carefully:
•Only use with a power supply rated for 220-240V~, 50-60Hz.
•To avoid the risk of scalding, keep your body and face approximately 25cm from the
outlet of the steamer at all times.
•Do not immerse the steamer, power cord or plug into water.
•Do not put essential oils into the water tank – the boiling point is different. Failure to
follow this instruction may lead to explosion or fire, and will damage the steamer.
•Do not put any cleansers or chemical substance in the water tank.
•Before adding water, ensure the device is turned off and unplugged.
•Do not use with the power cord too close to the steamer.
•To avoid accidents and prevent the danger of scalding, ensure to use this device
only as directed within this user guide, and to use only with care.
•There may be residual water in the device’s tank when you open the package. That
is the residual water from the device testing. It will not lead to any health problems.
•The device must not be used by:
oPeople during pregnancy or while menstruating, as it may cause skin problems
due to hormone imbalance.
oPeople who have allergies, skin diseases, dermatitis, skin allergies or severe
sunburn.
oPeople with skin problems, like eczema or swelling.
oPeople who are recovering after a surgery.
•Do not touch any metal parts of the power plug when the power supply is turned
on.
•Do not pull or insert the plug with wet hands, otherwise it may cause electric shock
or may lead to short circuit.
•Do not allow children to use this device as it may cause burns, electric shock.
•Put this device on a flat surface while using, do not hold it on your hand.
•During use or within 10 minutes after use, do not tilt, shake, or move the device.
Otherwise the hot water may leak, or a lot of steam may come out from the steam
outlet.
•After using this device, let the water completely cool down, then pour out the
remaining water. Ensure to hold the device while pouring out the water.
•Ensure to clean the water droplets on the steam outlet. Otherwise, hot water might
spill out when the power supply is turned on for the next use.
SAFETY & WARNINGS

1
Steamer head
5
Opening for water tank
2
Steamer body
6
Power cord
3
Mode selector
7
Beaker
4
Removable water tank
OVERVIEW

Use only on a flat, level surface.
•Place the device on a flat, level and solid surface, such as a desk, table or bench.
•Do not hold the appliance in your hands during use.
Removing the water supply tank
•Pull up on the water tank to remove it from the device.
•Open the water supply cap by turning.
•Fill the water tank with distilled or purified only and close the water supply cap.
•Slide the water tank back into the opening on the device.
•Wipe away any water on the surface of the water supply tank.
Powering on
1. Connect the plug to a power outlet.
2. Rotate the Mode Selector switch to turn on the appliance and set to your intended
use (Warm Towel, Facial Steamer or Humidifier).
Refer to the following pages for each mode’s usage instructions.
GETTING STARTED
Note: Ensure the power is switched off when adding water.
Before First Use:
When new, this device will have some plastic smell. To reduce the smell, it is
recommended to run the device for about 5-8 minutes (or until the plastic smell fades)
prior to first use.

Using as a Steamer
1. Connect the plug to a power outlet.
2. Rotate the Mode Selector switch to
‘Facial Steamer’.
3. The LED indicator around selector switch
will turn blue. After approximately 1
minute, the steam will be released.
4. Direct the steam to your face. Keep your
face at least 25 cm (10”) away from the
spout (refer to Figure 1).
5. When using the appliance for the first
time, use your hand to feel the steam
temperature at a 25 cm distance before
placing your face into position.
6. To ensure that the steam covers your
entire face, direct the steam to the top of
your chin.
OPERATION
Note:
When done, turn the Mode Selector switch back to the ‘Off’ position.
Do not leave running, even when water is empty.
Figure 1

Using as a Towel Warmer
•Remove the steamer head by rotating it counter-clockwise, directing the arrow on
the head to the “unlocking” position (refer to Figure 2).
•When in position, lift the head to remove.
•Take a small, 100% cotton face towel and soak it with distilled or purified water.
Wring the towel to squeeze out the excess water until it is not dripping, then neatly
fold the towel and place it into the steamer body.
•Replace the steamer head, rotating back to locking position (refer to Figure 3).
•Connect the plug to a power outlet and rotate the Mode Selector switch to ‘Warm
Towel’.
•After two minutes of used, the towel will be warm and ready to use. Turn the Mode
Selector to ‘off’.
Note:
Turn off the power before removing the head, and ensure the device is cooled down.
Figure 2
Figure 3

•Ensuring no steam is rising, use forceps to pick the towel up and withdraw from the
device. The towel will be very hot, and we recommend shaking the towel several
times before touching.
•When you have checked that it is at a comfortable temperature, you may use it on
your face.
Using as a Humidifier
•This device can be used in dressing rooms, bedrooms or other small enclosed
rooms as an air humidifier.
•Fill the water tank with water and place it in the device.
•Connect the plug to a power outlet and rotate the Mode Selector switch to
‘Humidifier’.
•Full water tank will deliver hot steam for 40 minutes.
Note:
When done, turn the Mode Selector switch back to the ‘Off’ position.
Do not leave running, even when water is empty.

Fruit sauna function
•Prepare fruit or flowers by thinly slicing / preparing
to fit into the beaker.
•Remove the steamer head (following the same
steps as the Towel Warmer instructions).
•Gently place the beaker inside the unit (refer to
Figure 5)
•Replace steam head (ensure it is locked into
position) and set the Mode Selector to “Facial
Steamer”
Measuring
cup /
beaker Place in beaker
Fruit
Flowers
Essential Oils
Figure 5
Figure 4

Clean inside the main unit once a week to prevent water scale deposits, mineral build up or
bad odour while using.
We recommend you follow the below procedure for cleaning:
•Make sure steamer is turned off and unplugged.
•Remove the water tank and the steamer head.
•Prepare a 1:1 ratio of vinegar-to-water solution (1 cup) and pour it into the towel
chamber. Let it soak for about 30 minutes. Then shake the device a little and pour
the solution out.
•Rinse the towel chamber with pure distilled mineral-free water.
•If any residual odour remains, you may need to repeat this a few times.
•Replace the water tank and steamer head, ensuring the steamer head is locked
into position.
CLEANING & CARE

Rated Voltage
220-240V~
Rated Power
600W
Rated Frequency
50-60Hz
Max. Water Volume
200ML
Working Time
18-40min
Problem
Possible Cause
Solution
Device fails to heat up
Mode Selector not turned on
/ in proper position
Tu r n Mode Selector to desired
position
Device is not plugged in Connect power cord to
electrical outlet
Household Circuit Breaker
has tripped or blown a fuse
Reset Circuit Breaker or replace
fuse
Device heats up, but
fails to produce steam
Mineral build up in the device
Follow the Cleaning & Care
instructions to clean the
steamer and remove mineral
build up
The water tank is too low or
completely empty
Refill water tank (refer to
Getting Started page)
Device works loudly
and steam smells bad Mineral build up in the device
Follow the Cleaning & Care
instructions to clean the
steamer and remove mineral
build up
SPECIFICATIONS
TROUBLESHOOTING

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com.