Kohler 99460T-4 User manual

1223737-2A-E 1
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. Inspect the supply tubing for damage and leakage. Replace and maintain as necessary.
3. Observe local plumbing codes.
4. The minimum inlet water pressure for the diverter is 0.05MPa(0.5bar).
5. The highest working pressure for handspray is 0.5MPa(5 bar). If it exceeds 0.5MPa(5 bar), a pressure reducer is
needed. The highest water and environment temperature is 60°C. Please keep handspray, showerhead and the
shower arm away from heater, or it may become damaged and cause injury to the user.
HANDLE OPERATION
Lift handle gently. Turn clockwise for hot water, turn counter-colckwise for cold water. For 99460T, Water flows out
from spout when faucet diverter is in the normal position; lift the diverter gently, turn clockwise for handspray; shut
off the faucet, turn counter-clockwise until it stops.
STANDARD APPLICABLE
Special model meets or exceeds the following at date of manufacture: TIS
1223737-2A-E 4
INSTALLATION INSTRUCTIONS
99460T-4 R99460T-4 Wall Mount Bath Shower Faucet
99463T-4 Wall Mount Shower Faucet
99460T-4 R99460T-4 Wall Mount Bath Shower Faucet
99463T-4 Wall Mount Shower Faucet
KUMINKUMIN
ROUGH-IN DIMENSIONS
SERVICE PARTS
99460T-4 99463T-4
1500
G1/2˝
G1/2˝
188
150±15
Ø66
G1/2˝
G1/2˝
56
130
150±15
Ø66
G1/2˝
87
Ø90
226
49
40º
27
60
58
**Color code must be specified when ordering.
NOTE: For all Asia pacific regions (excluding China) add SP (SPxxxxxxx**) in front of the part number when ordering.
128
171
18º
G1/2˝
G1/2˝
66
1181007**
1219595**
3008523
3013706
1226316**
1209778**
1209777
1292054
864104**
1213567
3016381
99460T:3020067
99460T:1223034**
99460T:1223033**
99460T:1223039
99463T:3016381
99463T:1213561
1030624
1216770**
831727**

1223737-2A-E 2 1223737-2A-E 3
INSTALLATION CHECKOUT
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
INSTALLATION
How to Install Faucet
Use appropriate thread sealants or thread tape on pipe threads. Install the two
offset connectors(1) into the hot and cold supply pipes.
Adjust the center-to-center distance between the connectors to 150mm and
horizontally. They should extend 27mm from finished wall. Thread the
escutcheons(2) onto the connectors until they contact the finished wall.
Put the washers(3) into the nuts(4). Thread the nuts onto the connectors(1) and
tighten by wrench.
How to Install the Handspray
Remove the guard on the outlet connector firstly.
Put the washer(5) into end A of the hose(6), and then connect to the faucet
outlet(7). Put the washer(8) into end B of the hose, and install the regulator(9)
into the handspray(10) inlet if needed, then connect end B of the hose to the
handspray inlet.
How to Install the Bracket
Determine a suitable location on the finished wall to install the bracket. Mark
bracket base mounting hole locations on the wall according to the dimension.
Drill two holes on the finished wall, the holes should match the anchors(11).
Install the anchors.
Tighten screws(12) to secure bracket base(13, flat side upward). Put the
bracket(14) onto the bracket base and lock by stopper.
Hot
Cold
Ensure that all coupling nuts are tight.
Ensure that the handle is in the off position.
Turn on the main water supply, and check for leaks. Repair as needed.
99460T-4: Bath Shower Faucet
Remove the handspray(10). Remove the aerator(16) by coin. Run hot and cold
water through the faucet for about one minute to remove any debris. Check for
leaks. Remove any debris from the aerator.
Lift the diverter(15) gently, turn clockwise for handspray. Run hot and cold water
through the faucet for about one minute to remove any debris. Check for leaks.
Shut off the faucet, and reinstall the handspray and aerator.
99463T-4: Shower Faucet
Remove the handspray(10). Run hot and cold water through the faucet for
about one minute to remove any debris. Check for leaks. Shut off the faucet,
and reinstall the handspray.
1
2
150mm
27mm
10
27
12
14
13
11
3
4
10
8
7
9
B
5
A
6
15
10
16