5
Establishing Your Conference Call
Why dial from the office telephone? Because most digital
PBX systems, such as Nortel Meridian, Rolm and others do not accept
the analog dialing tones generated by the conference speakerphone.
In order to make a successful conference call you will have to manually
dial the phone number from the keypad of the DIGITAL OFFICE
TELEPHONE (not from the conference speakerphone).
Note: Some systems will allow you to dial the number directly from the
keypad of the conference speakerphone (autodial), however we
recommend using the following steps to ensure a successful call.
Step 1. Set the Telephone Level Switch on the KONFERENCE to the
proper setting for the telephone system (see table on page 7). If the
phone system is not listed, please see page 11 section C.
Step 2. If the digital office telephone has a volume control, ensure
that the volume is set to mid-range. Do this by lifting the handset
to your ear and adjust the volume control to mid-range.
Step 3. Lift the telephone handset from the cradle and get an outside
line (dial 9 or other prefixes if necessary) and manually dial the number
from whom you wish to call from the DIGITAL OFFICE TELEPHONE
(not from the conference speakerphone).
Continue to next page
