KTL Kidwin Flyer Series User manual

1
Fl
y
er Series

2
Fl
y
er Series
zReal Product Views:
Flyer 12D
Back View
Top View
Bottom View
Slide View
Front View

3
Fl
y
er Series
Flyer 15D
Back View
Slide View
Top View
Front View
Bottom View

4
Fl
y
er Series
Front View
Top View
Slide View Back View
Bottom View
Flyer 18D

5
Fl
y
er Series
Front View
Top View
Bottom View
Flyer 20D
Slide View Back View

6
Fl
y
er Series
zTwo ways of installation
¾
¾ F
Fi ix xe ed d i in ns st ta al ll la at ti io on n
¾
¾ H
Ha an ng gi in ng g
L
Lo oa ad d t th he e f fi ir rs st t p pa an ne el l : :
Top Flying Bar
4 pieces of M8x20 Mounting
screw – to be firmly
fixed onto the supporting
structure behind.

7
Fl
y
er Series
Turn the hand wheel to the left to raise up the kinpin fully, tightening it up by using the
supplied tool or a screw driver by inserting it into the hole of the hand wheel, then lock it up
firmly with the top flying bar.
z
z P Pa an ne el l t to o p pa an ne el l l lo oc ck ki in ng g: :
Refer to the
following pages for
details
Refer to the
following pages for
details

8
Fl
y
er Series
z
z L Lo oc ca al l I In ns st ta al ll la at ti io on n D Dr ra aw wi in ng g: :
S
St te ep p1 1. . T Tw wo o s si id de es s p pa an ne el l l lo oc ck ki in ng g a an nd d r re el le ea as se e
Lift up the handle for pushing the lock into the adjacent panel fully, then lock the two panels.
Push down the handle for releasing the lock, then unlock the two panels.
Lock & its handle

9
Fl
y
er Series
S
St te ep p2 2. . T Tw wo o v ve er rt ti ic ca al l p pa an ne el ls s l lo oc ck ki in ng g a an nd d r re el le ea as se e
Pull left and hold the humper, push the fastener to right to lock the two panels vertically
Pull left and hold the humper, push the fastener to left to unlock the two panels vertically
Humper
Fastener
With the Kinpin fully
raised up for locking up
two vertical panels
Hand wheel
Two vertical panels
are locked

10
Fl
y
er Series
z
z C Cu ur rv ve ed d S Sc cr re ee en n I In ns st ta al ll la at ti io on n O Op pt ti io on n: :
With the shown mechanical
accessories (optional),
panels can be installed
with an angle up to
+ / - 12°for curved applications
both inward or outward.
For Flyer 12D/Flyer 15D/Flyer 18D only
CCD calibration and
programming port
(Used by an experienced
engineer only)