KYOWA KW-1500 User manual

KYOWA SERVICE CENTER
Rm. 1203 State Center Building
#333 Juan Luna St., Binondo
Manila, Philippines
HOT AND COLD
WATER DISPENSER
MODEL # KW-1500
Voltage: 230V a.c. 60Hz Power: 550 W (Hot) –85 W (Cold)
INSTRUCTION MANUAL

IMPORTANT SAFEGUARDS
When using the Water Dispenser, basic safety precautions should always be
followed:
Always operate your KYOWA Water Dispenser from a power source of the
same voltage and frequency rating as indicated on the rating label.
Connect the Water Dispenser unit only to properly wired wall outlets.
Always keep the Water Dispenser upright –never tilt or turn the unit
upside-down. In case the unit was tilted during transportation, put up the
Water Dispenser for 48 hours before plugging into the power supply.
Do not use Water Dispenser in damp or wet area. Keep dry the motor and
the base of the unit.
Do not operate or place any part of your KYOWA Water Dispenser on or
near any hot surface such as a gas or electric burner, hotplate or heated
oven.
Place the Water Dispenser on a flat area surface. Never turn the unit
upside down.
Keep at least 20 cm. of space between the wall and the Water Dispenser.
This unit is most suitable for 3 to 5-gallon bottle of water.
Do not plug in Water Dispenser or set the Heating switch to ON until the
water runs out from the hot water tap.
Do not operate the Water Dispenser if any part of it has been damaged.
Return the appliance to the nearest authorized dealer or service facility
for repair.
Do not use or replace accessories other than the ones originally provided.
Hold plug when unplugging from socket. Do not unplug by pulling the
supply cord.
To reduce the risk of electric shock, do not immerse or expose the Water
Dispenser to rain, moisture or any liquid.
If this unit is not intended to be used for a long time, turn power switch
of Water Dispenser to OFF, unplug socket from the power supply and
drain out remaining water from the Water Dispenser unit.
Keep out of reach from children or from persons with mental or physical
disabilities.
This KYOWA Water Dispenser is intended for normal domestic/household
use only. This unit is not suitable for commercial use.
CONGRATULATIONS
You are now a proud new owner of a KYOWA Water Dispenser model
no. KW-1500.
Before using for the first time, kindly take time to carefully read your
instruction manual. Please observe all safety precautions and follow
operating procedures. After reading, kindly store your instruction manual in
a safe place for your future reference. Should you pass on this Water
Dispenser to a third party, please hand over this instruction manual as well.
PARTS DESCRIPTION
1
2

HOW TO USE
Remove all packaging materials from the Water Dispenser. Completely
untangle or unwind the power cable of the unit.
Before initial use, the Water Dispenser must be plugged into a wall
receptacle that is properly installed and grounded to reduce risk of
electric shock.
Allow about 1 liter of water to run out from the dispenser when using for
the first time.
Tear the label or any sealing material on the cover of the bottle.
Vertically insert the bottle supporter on top of the machine. Do not plug
in cord or turn the unit ON until water runs out from the hot water tap.
Cooling of water from the Water Dispenser normally takes about 3
minutes after the unit has been turned ON and the cooling switch has
been activated.
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Water coming out
from the hot and cold
dispenser is lukewarm
1. Water from the hot and
cold container has
already been consumed
2. No power supply
1. Wait for about three minutes
to allow cooling or heating of
water from the unit
2. Check if the power cord is
properly plugged into the
power supply
No water coming out
from the dispenser
1. The water bottle is
empty
2. Inlet of bottle
supporter is blocked
1. Replace with another bottle
of water.
2. Remove object that was
blocking the water flow
Water leaks coming
out from the bottle
supporter
The water bottle is
broken
Replace with a new bottle of
water
Too much noise when
dispensing water from
the unit
Water Dispenser is tilted
or not installed properly
Place unit upon a flat area and
stable surface
CLEAN AND CARE
Wash Bottle Supporter and Water Tank regularly to maintain optimum
performance of the Water Dispenser.
Do not use harsh cleaning agents or abrasive objects (e.g. scrubbing pads
or metal brushes) for cleaning.
Put back parts and accessories of the Water Dispenser to their proper
places before operating again.
Wipe dry all parts of the Water Dispenser using a soft and dry cloth.
SERVICE
Do not operate your KYOWA Water Dispenser if the unit malfunctions or
appears damaged in any manner. Bring the complete product to the place
of purchase or to any authorized KYOWA dealers for inspection, repair or
replacement.
Do not disassemble your KYOWA Water Dispenser by yourself. No user
serviceable parts inside. Refer all needed repair to an authorized KYOWA
service facility ONLY.
3
4