Aqua Cooler ODYSSEY Series User manual

Your Partner in Cool.
Usage and Care
Manual
Models:
AC-ODYBHC-BLK-CT
AC-ODYBCC-BLK-CT
ODYSSEY
SERIES

2Your Partner in Cool.
TECHNICAL SPECIFICATIONS
PRODUCT DIAGRAM
Water Reservoir Cold 2.5 L Hot (if applicable) 1.5 L
Housing Material Plastic with steel side panels and corner pieces
Refrigeration Uses R134A refrigerant
Thermostat Control The thermostat is factory set
Capacity Cold 2 L/h Hot (if applicable) 5 L/h
Power Consumption Cold 85W Hot (if applicable) 420W
Electrical 220V-240V, 50Hz
Warranty Twelve month comprehensive coverage. Three year compressor replacement.
Cold Bottled 100 W
Character
1.Modern design.
2.Energy-saving, low noise, resistant structure and great stability. Suitable for use in
homes, hotels, schools, etc.
3.The plastic parts of this product use high quality and durable plastic.
4.Double security system, “temperature control " and "heating protection". Hot water
temperature is always between 80 ° C and 95 ° C, enough to make coffee or tea, or
other instant food.
5.The water dispenser's cooling system is durable and suitable for use during the
summer.
6.This product can be used with bottled water or a water purifier.
Note: The graphic is for reference only. The current device may have
differences with the graphic.
Operation process
1.Insert the bottle vertically on the seat and press the water faucets until water flows
out of the red hot water faucet.
2.Insert the power plug to the wall socket and turn the electric switches to ON position
to start the appliance. DO NOT MOVE BOTH SWITCHES AT THE TIME. Cooling and
heating indicator lights should light up. The appliance is designed to provide hot or
cold water whenever you need it. It will automatically turn on and off when the water
reaches the desired temperatures.
Note: If technical data or the circuit graphic change, the information
sheet may not reflect those changes.
Parts name
Attention
1.Make sure to have poured water from the hot water faucet before plugging and
switching the appliance ON to heat. If the dispenser is turned ON with an empty water
tank, it can be damaged.
2.When you are ready to move the water cooler, do not tilt more than 45º to avoid
damage to the compressor.
3.Always install the dispenser indoors, on a flat surface and at a distance no less than
15 cm from the back wall.
4.Keep this appliance away from high temperatures and in a dry and ventilated place.
Never install it in the open air or under rain or direct sunlight.
5.Children should not use the red hot water tap.
6.If the appliance is not going to be used for a long period of time, unplug it and drain
all water in its interior.
7.Before the first use and after a long period of not using it, the water tank and water
pipes should be cleaned well. If possible, they should be disinfected and disinfect,
and the first heated water must be discarded (switch the heating switch to OFF while
draining the system).
8.Wash and disinfect the system every 3-6 months with a suitable cleaner and according to
its instructions for use.
Normal Water Faucet
Odyssey CT Ambient and Cold
220V-240V~50Hz
/
/
1. Bottle support/spike
2. Power switches (model dependent)
3. Indicator lights
4. Information plate
5. Child safety lock (model dependent)
6. Cold water faucet
7. Hot water/ambient water faucet (model
dependent)
8. Drip tray
9. Power cord
10. Drain plug

3
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should be followed to reduce the risk of re, electric
shock, and injury to persons or property. Read all instructions before using any appliance.
1. Make sure to have poured water before
plugging and switching the appliance ON.
If the dispenser is turned ON with an empty
water tank, it can be damaged. See installation
instruction section
2. When you are ready to move the water cooler,
do not tilt more than 45º to avoid damage to
the compressor.
3. Always install the dispenser indoors, on a at
surface and at a distance no less than 15cm
from the back wall.
4. Keep this appliance away from high
temperatures and in a dry and ventilated place.
Never install it in the open air or under rain or
direct sunlight.
5. If the appliance is not going to be used for a
long period of time, unplug it and drain all water
in its interior.
6. Before the rst use and after a long period of
not using it, the water tank and water pipes
should be cleaned well. If possible, they should
be disinfected.
7. Wash and disinfect the system every 3-6 months
with a suitable cleaner and according to its
instructions for use.
8. Do not pull out the cable to unplug. Do not turn
ON and OFF the appliance by connecting it and
disconnecting it from the source of electricity.
9. Do not clean the outside of the appliance with
water to avoid electric shock. Clean it with a
soft cloth.
10. If you are not using the appliance for a long
period of time or during the night, you can turn
it OFF to save energy.
11. Do not attempt to change the power cord
by yourself if it has any damage. Contact the
manufacturer or specialised service personnel.
12. If the power cable suffers any damage, contact
the manufacturer, service representative or
qualied personnel.
13. The equipment must be installed keeping easy
access to the electrical plug.
14. WARNING - to avoid the risks of an unstable
installation, the equipment must be installed
following its instructions.
15. WARNING - keep the ventilation openings
at the back of the appliance uncovered and
unobstructed.
16. NOTICE - do not damage the refrigerant circuit.
17. The environmental temperature for this
appliance should be between 18°C and 38°C.
18. This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
use maintenance should not be carried out
by children without supervision. Do not store
explosive substances such as aerosol cans with
a ammable propellant in this appliance. This
appliance is intended to be used in household
and similar applications such as
– staff kitchen areas, shops, ofces and other
working environments;
– clients in hotels, motels and other residential
type environments;
– bed and breakfast type environments;
– catering and similar non-retail applications
19. Do not place other appliances inside this
equipment unless those are recommended by
the manufacturer.
20. Do not store explosive substances such as spray
cans inside this appliance.
IMPORTANT INFORMATION ABOUT GROUNDING
• To provide additional protection from the risk of shock, this unit MUST be connected to a
power outlet protected by a RCD (safety switch) at all times. Use of an extension cord will void any
warranties.
• This appliance is equipped with a power cord having a grounding wire with a grounding plug and
must be connected into a properly-grounded, polarised outlet.
• Consult a qualied electrician if the grounding instructions are not completely understood, or if
doubt exists as to whether the appliance is properly grounded. If the wall outlet is a standard,
2-prong outlet, it is your personal responsibility and obligation to have it replaced with a
properly-grounded, 3-prong wall outlet.
• Do not under any circumstances cut or remove the third (ground) prong from the power cord plug.
Do not use an adapter plug with this appliance.

4Your Partner in Cool.
UNPACKING THE WATER COOLER
1. After unpacking the water cooler, wipe with a soft cloth.
2. Place the machine on a hard, at surface. Make certain the unit is level. The unit should not be close to
direct sunlight or other sources of heat.
3. It is best to place the water cooler in an area with good air circulation. Make sure there is at least 10 cm
of space between the back of your cooler and the wall. Keep a minimum distance of 5 cm on each side of
your water cooler.
INSTALLATION PROCEDURE
1. Make sure the water dispenser is not plugged into an electrical outlet.
2. Remove the bottle support by twisting in the direction specied to access tank
3. Flush tank with water and wipe with soft cloth
4. Insert the water bottle vertically on the bottle support/spike of the water dispenser.
5. Wait until the tanks ll with water. Press the cold water tap down until water begins to ow. Press the hot
water tap (if applicable) down until water begins to ow.
6. Flush through 5L of water to ensure lines are cleaned. More may be required if taste is strange. Once
ushed, ensure the cooler tanks are full of water before moving to step 7.
7. Insert the power plug into an electrical outlet.
8. Turn the electric switches to ON position to start the appliance.
DO NOT MOVE BOTH SWITCHES AT THE SAME TIME. ENSURE STEP THREE IS COMPLETED FIRST
9. Indicator lights on front should light up. The appliance is designed to provide water whenever you need it.
It will automatically turn on and off when the water reaches the desired temperatures. The indicator lights
will not show all the time.
10. When heating light turns off, the heating tank is at temperature. Make sure to drain the hot tank through
the tap after the rst heating cycle and dispose of water.
WARNING - The drain cap on the back of the unit may become loose during shipping. Fasten the drain
cap tightly before you start to operate the unit. If the drain cap is loose, the unit may leak and cause
oor damage.
CLEANING AND MAINTENANCE
• Remove or disconnect power before performing any maintenance or servicing the product.
• Never use detergent or chemicals to clean the water tanks.
• If dust or other exterior substance has accumulated on the condenser, wipe off with water-soaked soft cloth.
• Do not directly spray water on the surface of the product. Wipe the front and back of the product with
water-soaked soft cloth.
• After cleaning the product, ensure it is completely dried before beginning use again.

5
TROUBLESHOOTING
Problem Possible Cause Remedy
Unit does not dispense cold
water.
Over consumption of cold water in a short
time.
Wait for 15 minutes while the water cools and
try again.
System malfunction. Contact Aqua Cooler service team.
The ventilation around the unit is insufcient. Ensure sufcient ventilation space around the unit.
The cold water switch is damaged or does
not make contact
Replace the switch and check the electrical
connection
The electrical connection is loose Repair connection
The temperature of the water in the water
bottle is too high.
Ensure the unit is not placed in direct sunlight or
close to other heat sources.
The cold water switch is in the OFF position. Switch the cold water switch to the ON position.
Cold water bafe is not set properly. Secure the cold water bafe in the cold tank.
Unit does not dispense hot
water (model dependent)
Over consumption of hot water in a short
time
Wati for 15 minutes while the water heats and
try again
The hot water switch is damaged or does not
make contact
Replace the switch and check the electrical
connection
The heating tank element is burnt out Replace heating tank element
The electrical connection is loose Repair electrical connections
The hot water switch is in the OFF position Switch the hot water switch to the ON position.
Unit is noisy during
operation.
The appliance is not level. Place the unit on a level, at surface.
Unit is touching other objects. Ensure the unit is standing free of any surrounding
objects.
Water leaks from the faucet.
The top portion of the faucet has come loose. Tighten the top threaded portion of the faucet.
The water container is broken. Replace the water container
The water pipe is broken. Replace the water pipe
The faucet has been damaged. Replace the faucet or contact Aqua Cooler service
team.
Lights are not functioning
Appliance is not connected to the electrical
system.
Make sure the switch is ON and the plug is
connected.
The switch is not ON Turn the switch into ON or turn the timer
Water is dripping out of
the water cooler and onto
the oor.
The hose connnector is not connected
properly.
Make sure the hose connector is properly
connected.
The inside water tanks are leaking. Contact Aqua Cooler service team.
The drain cap on the back is not fastened
correctly.
Tighten the drain cap. If the sealing silicon
material inside the drain cap is torn or damaged,
then replcae with a new one.
Crack or pin holes in the bottle. Replace with a new bottle.
The water being dispensed
has a strange taste.
This is not uncommon with new water
coolers. Do not worry, this is not dangerous
to your health.
Clean the hose in the dishwasher (top rack only)
or let it soak in dish soap. The strange taste
usually goes away after the rst bottle has been
consumed.

Your Partner in Cool.

Your Partner in Cool.

Your Partner in Cool.
Phone Numbers
Sales: 1300 278 226
Service: 1800 278 226
Address
U14, 2-12 Knobel Court
Shailer Park QLD 4128
Internet
www.aquacooler.com.au
[e-mail]